Nissan Pathfinder (2011 year). Manual — part 564
OCCUPANT CLASSIFICATION SYSTEM
SRC-11
< SYSTEM DESCRIPTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
Passenger does not meet Occupant Classification System specifications for passenger air bag activation.
WHIA0195E
2011 Pathfinder
SRC-12
< SYSTEM DESCRIPTION >
PASSENGER SEAT BELT WARNING SYSTEM
PASSENGER SEAT BELT WARNING SYSTEM
System Diagram
INFOID:0000000006245251
System Description
INFOID:0000000006245252
The passenger seat belt warning system will remind the driver if the
driver or front passenger seat belt should be buckled by turning on
the seat belt warning light (1). The system works in conjunction with
the occupant classification system. Refer to
Passenger Seat Belt Warning System Operation
Component Parts Location
INFOID:0000000006245253
SRC-7, "SRS Component Parts Location"
ALHIA0028GB
ALHIA0043ZZ
Driver seat status
(Ignition switch ON)
Passenger seat status
Seat belt buckle switch
LH status
Seat belt buckle switch
RH status
Seat belt warning lamp
Seat occupied
Seat occupied
Buckled
Buckled
Off
Unbuckled
On
Seat unoccupied
—
Off
—
Unbuckled
On
2011 Pathfinder
ON BOARD DIAGNOSTIC (OBD) SYSTEM
SRC-13
< SYSTEM DESCRIPTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
ON BOARD DIAGNOSTIC (OBD) SYSTEM
Trouble Diagnosis Introduction
INFOID:0000000006245254
CAUTION:
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to do so in
this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harness con-
nectors.
• Do not attempt to repair, splice or modify SRS wiring harnesses. If a harness is damaged, replace it
with a new one.
• Keep ground connections clean.
DIAGNOSIS FUNCTION
The SRS self-diagnosis results can be read by using “AIR BAG” warning lamp and/or CONSULT.
The User mode is exclusively prepared for the customer (driver). This mode warns the driver of a system mal-
function through the operation of the “AIR BAG” warning lamp.
The Diagnosis mode allows the technician to locate and inspect the malfunctioning part.
The mode applications for the “AIR BAG” warning lamp and CONSULT are as follows:
HOW TO PERFORM TROUBLE DIAGNOSES FOR QUICK AND ACCURATE REPAIR
A good understanding of the malfunction conditions can make troubleshooting faster and more accurate.
In general, each customer feels differently about a malfunction. It is important to fully understand the symp-
toms or conditions for a customer complaint.
Information From Customer
WHAT - Vehicle model
WHEN - Date, Frequencies
WHERE - Road conditions
HOW - Operating conditions, Symptoms
Preliminary Check
Check that the following parts are in good order.
• Battery
• Fuses
• System component-to-harness connections
SRS Operation Check
INFOID:0000000006245255
DIAGNOSTIC PROCEDURE 1
Checking SRS Operation Using “AIR BAG” Warning Lamp—User Mode
1. Turn the ignition switch from OFF to ON, and check that the air bag warning lamp blinks.
2. Compare the SRS air bag warning lamp blinking pattern with the
examples.
User mode
Diagnosis mode
Display type
“AIR BAG” warning lamp
X
X
ON-OFF operation
CONSULT
—
X
Monitoring
BF-1845D
2011 Pathfinder
SRC-14
< SYSTEM DESCRIPTION >
ON BOARD DIAGNOSTIC (OBD) SYSTEM
SRS Air bag warning lamp examples
DIAGNOSTIC PROCEDURE 2
1. Connect CONSULT.
2. Diagnostic code is displayed on "SELF-DIAG [CURRENT]".
If no malfunction is detected on "SELF-DIAG [CURRENT]", but malfunction is detected in "SRS Operation
Check" using the "AIR BAG" warning lamp, the following cases may exist:
• "SELF-DIAG [PAST]" memory might not be erased.
• The SRS system malfunctions intermittently.
Perform DIAGNOSTIC PROCEDURE 4. Refer to
SRC-15, "Self-Diagnosis Function (Without CON-
“AIR BAG” warning lamp (User mode)
SRS condition
Reference item
• No malfunction is detected.
• No further action is necessary.
—
The system is malfunctioning and
needs to be repaired as indicated.
Go to DIAGNOSTIC PROCEDURE
2 that follows (with CONSULT) or
SRC-15, "Trouble Diagnosis without
CONSULT"
(without CONSULT).
• Air bag is deployed.
• Seat belt pre-tensioner is deployed.
Go to COLLISION DIAGNOSIS
"For Side and Rollover Collision"
.
• Air bag diagnosis sensor unit is mal-
functioning.
• Air bag power supply circuit is mal-
functioning.
• SRS air bag warning lamp circuit is
malfunctioning.
Go to
.
• Air bag diagnosis sensor unit is mal-
functioning.
• Air bag warning lamp circuit is mal-
functioning.
Go to
.
SHIA0011E
SHIA0012E
SHIA0013E
SHIA0014E
2011 Pathfinder
ON BOARD DIAGNOSTIC (OBD) SYSTEM
SRC-15
< SYSTEM DESCRIPTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
Trouble Diagnosis without CONSULT
INFOID:0000000006245256
DIAGNOSTIC PROCEDURE 6
Inspect SRS Malfunction Using "AIR BAG" Warning Lamp—Diagnosis Mode
NOTE:
SRS will not enter Diagnosis mode if no malfunction is detected in User mode.
1. Turn ignition switch ON.
2. After “AIR BAG” warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
3. Wait more than 3 seconds.
4. Repeat steps 1 to 3 two more times (3 times total).
5. Turn ignition switch ON.
SRS is now in Diagnosis mode. Refer to
SRC-69, "Trouble Diagnosis without CONSULT"
.
CONSULT Function (AIR BAG)
INFOID:0000000006245257
CONSULT can display each diagnostic item using the diagnostic test modes shown following.
Self-Diagnosis Function (Without CONSULT)
INFOID:0000000006245258
• The reading of these results is accomplished using one of two modes —“User mode” and “Diagnosis mode”.
• After a malfunction is repaired, turn the ignition switch OFF for at least one second, then back ON. Diagnosis
mode returns to the User mode. At that time, the self-diagnostic result is cleared.
AIR BAG diagnostic mode
Description
SELF-DIAG [CURRENT]
A current Self-diagnosis result (also indicated by the number of warning lamp flashes in the Diagnosis
mode) is displayed on the CONSULT screen in real time. This refers to a malfunctioning part requiring
repairs.
SELF-DIAG [PAST]
Diagnosis results previously stored in the memory are displayed on the CONSULT screen. The stored
results will remain until memory erasing is executed.
TROUBLE DIAG RECORD
With TROUBLE DIAG RECORD, diagnosis results previously erased by a reset operation can be dis-
played on the CONSULT screen.
ECU DISCRIMINATED NO.
Air bag diagnosis sensor unit ECU discriminated number (identification number) or part number is dis-
played. Air bag diagnosis sensor unit has individual ECU discriminated number (identification number)
or part number based on model and equipment.
PASSENGER AIR BAG
The STATUS (readiness) of the front passenger air bag module is displayed. The STATUS displayed
(ON/OFF) depends on the signals supplied to the occupant classification system control module and
air bag diagnosis sensor unit. Refer to
SRC-10, "Occupant Classification System (OCS)"
formation.
2011 Pathfinder
SRC-16
< SYSTEM DESCRIPTION >
ON BOARD DIAGNOSTIC (OBD) SYSTEM
HOW TO CHANGE SELF-DIAGNOSIS MODE
DIAGNOSTIC PROCEDURE 3
Final Check of SRS Using CONSULT—Diagnosis Mode
1. Connect CONSULT.
2. If no DTC is detected on “SELF-DIAG [CURRENT]”, repair of SRS is completed. Go to step 3.
If any DTC is detected on “SELF-DIAG [CURRENT]”, the malfunctioning part has not been repaired com-
pletely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to
.
3. Touch “ERASE”.
NOTE:
Touch “ERASE” to clear the memory of the malfunction (“SELF-DIAG [PAST]”).
If the memory of the malfunction in “SELF-DIAG [PAST]” is not erased, the User mode shows the system
malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
4. Touch “BACK” key of CONSULT. Touch “SELF-DIAG [PAST]”.
5. Check that no malfunction is detected on “SELF-DIAG [PAST]”.
6. Touch “BACK” key of CONSULT to return to User mode from Diagnosis mode.
7. Turn ignition switch OFF and then turn off and disconnect CONSULT.
8. Go to
DIAGNOSTIC PROCEDURE 4
Check SRS Repair History
1.
CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR
Check repair history of the SRS.
Have any previous repairs been made to the SRS?
YES
>> Self-diagnostic result “SELF-DIAG [PAST]” (previously stored in the memory) might not be erased
after repair. Perform DIAGNOSTIC PROCEDURE 3. Refer to
SRC-15, "Self-Diagnosis Function
NO
>> Perform DIAGNOSTIC PROCEDURE 2. Refer to
.
SHIA0183E
2011 Pathfinder
B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE
SRC-17
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
DTC/CIRCUIT DIAGNOSIS
B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE
Description
INFOID:0000000006245259
DTC B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE
The driver air bag module is dual stage and wired to the air bag diagnosis sensor unit through the spiral cable.
The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the driver air bag mod-
ule including the spiral cable.
PART LOCATION
SRC-7, "SRS Component Parts Location"
DTC Logic
INFOID:0000000006245260
DTC DETECTION LOGIC
With CONSULT
Without CONSULT
DTC CONFIRMATION PROCEDURE (With CONSULT)
CONSULT name
DTC
DTC detecting condition
Repair order
DRIVER AIRBAG MODULE
[OPEN]
B1049
Driver air bag module circuit (DR1) is open
(including the spiral cable).
1.
Visually check the wiring harness connection.
2.
Replace the harness if it has visible damage.
3.
Inspect spiral cable circuit.
4.
Replace the air bag diagnosis sensor unit.
5.
Replace the driver air bag module.
6.
Replace the related harness.
B1054
Driver air bag module circuit (DR2) is open
(including the spiral cable).
DRIVER AIRBAG MODULE
[VB-SHORT]
B1050
Driver air bag module circuit (DR1) is
shorted to a power supply circuit
(including the spiral cable).
B1055
Driver air bag module circuit (DR2) is
shorted to a power supply circuit
(including the spiral cable).
DRIVER AIRBAG MODULE
[GND-SHORT]
B1051
Driver air bag module circuit (DR1) is
shorted to ground
(including the spiral cable).
B1056
Driver air bag module circuit (DR2) is
shorted to ground
(including the spiral cable).
DRIVER AIRBAG MODULE
[SHORT]
B1052
Driver air bag module circuits (DR1) are
shorted to each other
(including the spiral cable).
B1057
Driver air bag module circuits (DR2) are
shorted to each other
(including the spiral cable).
AWHIA0311GB
2011 Pathfinder
SRC-18
< DTC/CIRCUIT DIAGNOSIS >
B1049 – B1052, B1054 – B1057 DRIVER AIRBAG MODULE
1.
INSPECTION START
Turn ignition switch ON.
>> GO TO 2.
2.
CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT.
Is the DTC detected?
YES
>> Refer to
SRC-18, "Diagnosis Procedure (Component Diagnosis)"
.
NO
>> Inspection End.
DTC CONFIRMATION PROCEDURE (Without CONSULT)
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3
3.
WAIT TIME
Wait more than 3 seconds.
>> GO TO 4
4.
REPEAT STEPS
Repeat steps 1 to 3 twice.
>> GO TO 5.
5.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 6.
6.
DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to
>>
END
Diagnosis Procedure (Component Diagnosis)
INFOID:0000000006245261
Recheck SRS after each replacement.
1.
HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 2
2011 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст