Nissan Teana J32. Manual — part 83
AV
INSPECTION AND ADJUSTMENT
AV-187
< BASIC INSPECTION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : De-
scription
INFOID:0000000003765633
WITH AROUND VIEW MONITOR
Always correct the center position of the predicted course line after disconnecting the battery negative termi-
nal.
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Spe-
cial Repair Requirement
INFOID:0000000003765634
1.
CORRECTION OF CENTER POSITION OF PREDICTED COURSE LINE
Refer to the following for details.
>> Refer to
AV-187, "PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT : Special
.
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
INFOID:0000000003765635
When camera control unit is replaced, the center position of predicted course line shall be corrected.
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Re-
quirement
INFOID:0000000003765636
1.
CORRECTION OF CENTER POSITION OF PREDICTED COURSE LINE
Refer to the following for details.
>> Refer to
AV-187, "PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT : Special
.
PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT
PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT : Description
INFOID:0000000003765637
Adjust the center position of the possible route line of the rear view monitor if it is shifted.
PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT : Special Repair
Requirement
INFOID:0000000003765638
1.
STEERING OPERATION
Steer the steering wheel to the leftmost and rightmost ends.
>> GO TO 2.
2.
DRIVING
Drive the vehicle straight ahead 100 m (328.1 ft) or more at a speed of 30 km/h (18.6 MPH) or more.
>> END
AV-188
< FUNCTION DIAGNOSIS >
[BOSE AUDIO WITHOUT NAVIGATION]
MULTI AV SYSTEM
FUNCTION DIAGNOSIS
MULTI AV SYSTEM
System Diagram
INFOID:0000000003765641
NOTE:
• The name MULTIFUNCTION SWITCH indicates the integration of PRESET SWITCH and MULTIFUNCTION
SWITCH virtually.
• A radio antenna base integrated with radio antenna amp. is adopted.
• Woofer illustrated in the above figure, integrates two woofers and a woofer amp.
System Description
INFOID:0000000003791244
Multi AV system means that the following systems are integrated.
• AV control unit controls by transmitting/receiving data one by one with each unit (slave unit) that configures
them completely as a master unit by connecting between units that configure MULTI AV system with two AV
communication lines (H, L).
JSNIA1296GB
System name
System explanation
AUDIO SYSTEM
REAR VIEW MONITOR SYSTEM
VEHICLE INFORMATION SYSTEM
• Status of audio, climate control system, fuel economy, mainte-
nance and navigation is displayed.
• AV control unit displays the fuel consumption status while re-
ceiving data signal through CAN communication from ECM and
combination meter.
• AV control unit is connected to BCM via CAN communication
transmitting/receiving for the vehicle settings function.
DVD ENTERTAINMENT SYSTEM
Refer to the following “DVD ENTERTAINMENT SYSTEM”.
AUXILIARY INPUT SYSTEM
Refer to “AUXILIARY INPUT SYSTEM” shown below.
AV
MULTI AV SYSTEM
AV-189
< FUNCTION DIAGNOSIS >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
• Two AV communication lines (H, L) adopt a twisted pair line that is resistant to noise.
• AV control unit is connected by CAN communication, and it receives data signal from ECM, combination
meter. It computes and displays fuel economy information value with the obtained information. Transmitting/
receiving of data signal is performed by BCM. Also, it transmits the required signal of vehicle setting and
receives the response signal.
• AV control unit is connected with display unit and serial communication, and it transmits the required signal
of display and display control and receives the response signal from display unit.
NOTE:
AV control unit can perform CONSULT-III self-operating function and on board self-diagnosis.
• CONSULT-III self diagnosis: Refer to
AV-211, "CONSULT-III Function (MULTI AV)"
• On board self diagnosis: Refer to
AV-200, "Diagnosis Description"
DVD ENTERTAINMENT SYSTEM
• DVD player is connected with AV control unit via AV communication, and controlled by AV control unit.
• DVD image signal is output from DVD player to display unit via AV control unit.
• DVD stereo (2ch) sound signal is output from DVD player to each speaker via AV control unit and BOSE
amp.
• DVD surround (5.1ch) sound signal is output from DVD player to each speaker via BOSE amp.
• Operation can be performed with multifunction switch, steering switch and rear control switch. Multifunction
switch and rear control switch transmits operation signal to AV control unit by AV communication.
AUXILIARY INPUT SYSTEM
• Image and sound can be output from an external device by connecting a device with auxiliary input jacks.
• Operation can be performed with multifunction switch, steering switch and rear control switch. Multifunction
switch and rear control switch transmits operation signal to AV control unit by AV communication.
JSNIA1299GB
JSNIA1301GB
AV-190
< FUNCTION DIAGNOSIS >
[BOSE AUDIO WITHOUT NAVIGATION]
MULTI AV SYSTEM
Component Parts Location
INFOID:0000000003765643
1.
Front squawker RH
2.
Center speaker
3.
Front squawker LH
4.
Front door speaker LH
5.
Rear door speaker LH
6.
Rear control switch
7.
Rear squawker LH
8.
Woofer LH
9.
BOSE amp.
10. Rear view camera
11. Woofer RH
12. Camera control unit
13. Rear squawker RH
14. Antenna amp.
15. Rear door speaker RH
16. Front door speaker RH
17. Steering angle sensor
18. Steering switch
19. AV control unit
20. Auxiliary input jacks
21. Preset switch
22. DVD player
23. Multifunction switch
24. Display unit
A. Trunk room upper RH
B.
Trunk room side RH
C.
Within rear pillar finisher RH
D.
Spiral cable part
E.
In center console
F.
In grove box
JPNIA1058ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст