Nissan Teana J32. Manual — part 606
EXT-34
< ON-VEHICLE REPAIR >
DOOR OUTSIDE MOLDING
REAR DOOR OUTSIDE MOLDING
1.
Remove rear door finisher. Refer to
INT-36, "Removal and Installation"
.
2.
Twists and pull up to upper side, and then remove rear door out-
side molding (1).
INSTALLATION
Install in the reverse order of removal.
JMKIA0117GB
DOOR PARTING SEAL
EXT-35
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
DOOR PARTING SEAL
Exploded View
INFOID:0000000003819551
Removal and Installation
INFOID:0000000003819552
REMOVAL
FRONT DOOR PARTING SEAL
1.
Fully open front door.
2.
Remove front door parting seal fixing plastic clips.
3.
Remove front door parting seal.
REAR DOOR PARTING SEAL (REAR DOOR LOWER SIDE)
1.
Fully open rear door.
2.
Remove rear door parting seal fixing plastic clips.
3.
Remove rear door parting seal.
REAR DOOR PARTING SEAL (REAR DOOR FRONT SIDE)
1.
Disengage rear door panel and rear parting seal (rear door front side), and then remove rear door parting
seal (rear door front side).
INSTALLATION
Install in the reverse order of removal.
1.
Rear door parting seal (rear door
front side)
2.
Rear door panel
3.
Rear door parting seal (rear door
lower side)
4.
Front door parting seal
5.
Front door panel
JMKIA2658ZZ
EXT-36
< ON-VEHICLE REPAIR >
SIDE GUARD MOLDING
SIDE GUARD MOLDING
Component Parts Location
INFOID:0000000003869335
Removal and Installation
INFOID:0000000003869336
REMOVAL
1.
Apply protection tape around outer circumference of side guard molding.
2.
Remove double-faced adhesive tapes with (wide) resin spatula. Disengage clips and remove side guard
molding (front / rear).
INSTALLATION
1.
Remove double-faced adhesive tape remaining on vehicle.
2.
Clean contact surface of vehicle (to side guard molding), and install side guard molding to specified holes.
NOTE:
To re-use side guard molding, follow above steps 1 and 2 as well; clean surface after removing double-
faced adhesive tape, apply new double-faced adhesive tape and then install side guard molding to vehi-
cle.
CAUTION:
• Never let air between contact surfaces when installing.
• To secure contact, never wash vehicle within 24 hours after installation.
1.
Front door panel
2.
Side guard molding clip
3.
Side guard molding (front)
4.
Side guard molding (rear)
5.
rear door panel
6.
Double-faced adhesive tape
: Clip
Refer to
of symbols in the figure.
JMKIA2656ZZ
SIDE GUARD MOLDING
EXT-37
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
• When installing, visually check the side guard molding and the clips, then replace them with new
parts if they are damaged.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст