Nissan Teana J32. Manual — part 1198
TM-316
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
TRANSMISSION CONTROL MODULE
CAUTION:
After TCM is replaced, refer to
TM-179, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT :
CONTROL DEVICE
TM-317
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
CONTROL DEVICE
Exploded View
INFOID:0000000003890382
Removal and Installation
INFOID:0000000003890383
REMOVAL
1.
Disconnect the battery cable from the negative terminal.
1.
Selector lever knob
2.
Lock pin
3.
Knob cover
4.
Control device assembly
5.
Shift lock unit
6.
Dust cover
Refer to
JPDIA0741GB
TM-318
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
CONTROL DEVICE
2.
Slide knob cover (1) below selector lever downward.
CAUTION:
Be careful not to damage knob cover.
3.
Pull lock pin (2) out of selector lever knob (3).
4.
Remove selector lever knob and knob cover.
5.
Remove center console assembly. Refer to
.
6.
Remove control cable (1) from control device assembly. Refer to
7.
Remove control device assembly (2).
8.
Remove control device connector (A) using a flat-bladed screw-
driver (B).
CAUTION:
Be careful not to damage control device connector.
9.
Remove shift lock unit from control device assembly.
INSTALLATION
Note the following, and install in the reverse order of removal.
When installing control cable (1) to control device assembly (2),
check that control cable is fully pressed in with the ribbed (A) surface
facing upward.
Inspection and Adjustment
INFOID:0000000003890384
ADJUSTMENT AFTER INSTALLATION
Adjust the CVT positions after installing control device. Refer to
TM-152, "Inspection and Adjustment"
.
INSPECTION AFTER INSTALLATION
Check the CVT positions after adjusting the CVT positions. Refer to
TM-152, "Inspection and Adjustment"
JPDIA0606ZZ
: Bolt
JPDIA0615ZZ
JPDIA0616ZZ
JPDIA0609ZZ
CONTROL CABLE
TM-319
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
CONTROL CABLE
Exploded View
INFOID:0000000003806518
Removal and Installation
INFOID:0000000003806519
REMOVAL
CAUTION:
Check that parking brake is applied before removal/installation.
1.
Disconnect control cable from control device assembly. Refer to
2.
Remove the air duct (inlet) and air cleaner case. Refer to
.
3.
Remove control cable (1) from manual lever (A).
4.
Remove lock plate (2) from control cable.
5.
Remove control cable from bracket 2 (3).
6.
Remove exhaust front tube. Refer to
7.
Remove heat plate.
1.
Bracket 1
2.
Lock plate
3.
Bracket 2
4.
Transaxle assembly
5.
Control cable
6.
Control device assembly
Refer to
JPDIA0742GB
: Nut
JPDIA0738ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст