Nissan Teana J32. Manual — part 440
EC-298
< COMPONENT DIAGNOSIS >
[VQ25DE, VQ35DE]
P2101 ELECTRIC THROTTLE CONTROL FUNCTION
5.
Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
>> GO TO 8.
NO
>> Repair or replace malfunctioning part.
8.
CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
1.
Remove the intake air duct.
2.
Check if foreign matter is caught between the throttle valve (1)
and the housing.
Is the inspection result normal?
YES
>> GO TO 9.
NO
>> Remove the foreign matter and clean the electric throttle
control actuator inside.
9.
CHECK THROTTLE CONTROL MOTOR
EC-298, "Component Inspection"
Is the inspection result normal?
YES
>> GO TO 10.
NO
>> GO TO 11.
10.
CHECK INTERMITTENT INCIDENT
GI-35, "Intermittent Incident"
Is the inspection result normal?
YES
>> GO TO 11.
NO
>> Repair or replace harness or connectors.
11.
REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1.
Replace electric throttle control actuator.
2.
EC-299, "Special Repair Requirement"
>> INSPECTION END
Component Inspection
INFOID:0000000003856786
1.
CHECK THROTTLE CONTROL MOTOR
1.
Turn ignition switch OFF.
2.
Disconnect electric throttle control actuator harness connector.
3.
Check resistance between electric throttle control actuator terminals as per the following.
Is the inspection result normal?
Electric throttle control actuator
ECM
Continuity
Connector
Terminal
Connector
Terminal
F29
5
F7
5
Not existed
6
Existed
6
5
Existed
6
Not existed
2: Electric throttle control actuator
JMBIA1390ZZ
Terminals
Resistance
5 and 6
Approx. 1 - 15
Ω
[at 25
°
C (77
°
F)]
P2101 ELECTRIC THROTTLE CONTROL FUNCTION
EC-299
< COMPONENT DIAGNOSIS >
[VQ25DE, VQ35DE]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
YES
>> INSPECTION END
NO
>> GO TO 2.
2.
REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1.
Replace electric throttle control actuator.
2.
Go to
EC-299, "Special Repair Requirement"
.
>> INSPECTION END
Special Repair Requirement
INFOID:0000000003858126
1.
PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
EC-16, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement"
>> GO TO 2.
2.
PERFORM IDLE AIR VOLUME LEARNING
EC-16, "IDLE AIR VOLUME LEARNING : Special Repair Requirement"
>> END
EC-300
< COMPONENT DIAGNOSIS >
[VQ25DE, VQ35DE]
P2118 THROTTLE CONTROL MOTOR
P2118 THROTTLE CONTROL MOTOR
Description
INFOID:0000000003856788
The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
The current opening angle of the throttle valve is detected by the throttle position sensor. The throttle position
sensor provides feedback to the ECM, when opens/closes the throttle valve in response to driving conditions
via the throttle control motor.
DTC Logic
INFOID:0000000003856789
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
>> GO TO 2.
2.
PERFORM DTC CONFIRMATION PROCEDURE
1.
Turn ignition switch ON and wait at least 2 seconds.
2.
Start engine and let it idle for 5 seconds.
3.
Check DTC.
Is DTC detected?
YES
>> Go to
.
NO
>> INSPECTION END
Component Inspection
INFOID:0000000003858132
1.
CHECK THROTTLE CONTROL MOTOR
1.
Turn ignition switch OFF.
2.
Disconnect electric throttle control actuator harness connector.
3.
Check resistance between electric throttle control actuator terminals as per the following.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> GO TO 2.
2.
REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1.
Replace electric throttle control actuator.
2.
Go to
EC-299, "Special Repair Requirement"
.
>> INSPECTION END
Special Repair Requirement
INFOID:0000000003858127
1.
PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
P2118
Throttle control motor
circuit short
ECM detects short in both circuits between
ECM and throttle control motor.
• Harness or connectors
(Throttle control motor circuit is shorted.)
• Electric throttle control actuator
(Throttle control motor)
Terminals
Resistance
5 and 6
Approx. 1 - 15
Ω
[at 25
°
C (77
°
F)]
P2118 THROTTLE CONTROL MOTOR
EC-301
< COMPONENT DIAGNOSIS >
[VQ25DE, VQ35DE]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
EC-16, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement"
>> GO TO 2.
2.
PERFORM IDLE AIR VOLUME LEARNING
EC-16, "IDLE AIR VOLUME LEARNING : Special Repair Requirement"
>> END
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст