Nissan Tiida C11. Manual — part 1234
STR-22
< SYMPTOM DIAGNOSIS >
[MR18DE]
STARTING SYSTEM
SYMPTOM DIAGNOSIS
STARTING SYSTEM
Symptom Table
INFOID:0000000001728572
Symptom
Reference
No normal cranking
Refer to
Starter motor does not rotate
PRECAUTIONS
STR-23
< PRECAUTION >
[MR18DE]
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000001689455
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
STR-24
< ON-VEHICLE REPAIR >
[MR18DE]
STARTER MOTOR
ON-VEHICLE REPAIR
STARTER MOTOR
Removal and Installation
INFOID:0000000001689442
REMOVAL
1.
Disconnect the battery cable from the negative terminal.
2.
Disconnect the oil pressure switch connector.
3.
Remove “B” terminal nut and “B” terminal harness.
4.
Remove “S” terminal nut and “S” terminal harness.
5.
Remove starter motor bolts.
6.
Remove starter motor upward from the vehicle.
CAUTION:
Never damage oil pressure switch when removing starter motor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Be sure to tighten “B” terminal nut carefully.
1.
"S" terminal harness
2.
"B" terminal harness
3.
Starter motor
4.
Cylinder block
Engine front
WKIA5611E
DIAGNOSIS AND REPAIR WORKFLOW
STR-25
< BASIC INSPECTION >
[K9K]
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
INFOID:0000000001728601
OVERALL SEQUENCE
DETAILED FLOW
JSBIA0008GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст