Nissan Tiida C11. Manual — part 337
DLK-758
< REMOVAL AND INSTALLATION >
[WITHOUT I-KEY, WITH SUPER LOCK]
TRUNK LID
TRUNK LID
Fitting Adjustment
INFOID:0000000001732067
Longitudinal and lateral clearance adjustment
1.
With the striker released, loosen the trunk lid hinge nuts and close the trunk lid.
2.
Make the lateral clearance and the clearance to the rear window glass equal. Then open the trunk lid to
tighten the nuts.
Surface height adjustment
1.
Loosen the striker bolts. Raise the striker to the top position, and temporarily tighten the upper bolt.
2.
Close the trunk lid lightly and adjust the surface height. Then open the trunk lid and tighten the striker
bolts.
Trunk Lid Assembly
INFOID:0000000001732068
REMOVAL
1.
Remove the trunk lid finisher. Refer to
XX-XX, "*****"
.
2.
Remove the trunk lid wire harness.
1.
Rear fender
2.
Trunk lid
3.
Rear combination lamp
4.
Rear bumper fascia
a.
4.0
±
1.0 mm (0.16
±
0.04 in)
b.
3.5
±
1.0 mm (0.14
±
0.04 in)
c.
4.5
±
1.7 mm (0.03
±
0.06 in)
d.
7.0
±
2.2 mm (0.28
±
0.09 in)
LIIA2932E
TRUNK LID
DLK-759
< REMOVAL AND INSTALLATION >
[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
3.
Remove the nuts (a) and the trunk lid assembly (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installing, apply touch-up paint (body color) to the head of the hinge nuts.
Trunk Lid Lock
INFOID:0000000001732069
REMOVAL
1.
Remove the trunk lid finisher. Refer to
XX-XX, "*****"
.
2.
If equipped, disconnect the trunk lid lock cylinder rod.
3.
Remove the release cable.
4.
Disconnect the electrical connector (a), remove the bolts (b) and
the trunk lid lock (1).
INSTALLATION
Installation is in the reverse order of removal.
Trunk Lid Striker
INFOID:0000000001732070
REMOVAL
1.
Remove the trunk rear plate and trunk rear finisher. Refer to
XX-XX, "*****"
.
2.
Remove the bolts, disconnect the electrical connector and remove the trunk lock actuator.
3.
Remove the bolt and disconnect the trunk lid release cable.
LIIA2933E
LIIA2935E
DLK-760
< REMOVAL AND INSTALLATION >
[WITHOUT I-KEY, WITH SUPER LOCK]
TRUNK LID
4.
Remove the bolts (a) and the trunk lid striker (1).
INSTALLATION
Installation is in the reverse order of removal.
LIIA2934E
EC-1
ENGINE
C
D
E
F
G
H
I
J
K
L
M
SECTION
EC
A
EC
N
O
P
CONTENTS
ENGINE CONTROL SYSTEM
HR16DE (WITH EURO-OBD)
BASIC INSPECTION . . . . . . . . ...
DIAGNOSIS AND REPAIR WORKFLOW . . .
Work Flow . . . . . . . . . . . . . . . ...
Diagnostic Work Sheet . . . . . . . . . . .
INSPECTION AND ADJUSTMENT . . . . .
BASIC INSPECTION . . . . . . . . . . . . .
BASIC INSPECTION : Special Repair Require-
ment . . . . . . . . . . . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT . . . . . . . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT : Description . . . . . . . .
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT : Special Repair Requirement . .
IDLE SPEED . . . . . . . . . . . . . . . ..
IDLE SPEED : Description . . . . . . . . . ..
IDLE SPEED : Special Repair Requirement . . ...
IGNITION TIMING . . . . . . . . . . . . . ..
IGNITION TIMING : Description . . . . . . . ..
IGNITION TIMING : Special Repair Requirement
ACCELERATOR PEDAL RELEASED POSITION
LEARNING . . . . . . . . . . . . . . . .
ACCELERATOR PEDAL RELEASED POSITION
LEARNING : Description . . . . . . . . . . .
ACCELERATOR PEDAL RELEASED POSITION
LEARNING : Special Repair Requirement . . . ..
THROTTLE VALVE CLOSED POSITION LEARN-
ING . . . . . . . . . . . . . . . . . . . .
THROTTLE VALVE CLOSED POSITION
LEARNING : Description . . . . . . . . . . .
THROTTLE VALVE CLOSED POSITION
LEARNING : Special Repair Requirement . . . ..
IDLE AIR VOLUME LEARNING . . . . . . . .
IDLE AIR VOLUME LEARNING : Description . . .
IDLE AIR VOLUME LEARNING : Special Repair
Requirement . . . . . . . . . . . . . . .
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR . . . . . . . . . . . . . . . . . ...
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR : Description . . . . . . . . . . . .
MIXTURE RATIO SELF-LEARNING VALUE
CLEAR : Special Repair Requirement . . . . . .
FUNCTION DIAGNOSIS . . . . . . . ..
ENGINE CONTROL SYSTEM . . . . . . ..
System Diagram . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
MULTIPORT FUEL INJECTION SYSTEM . ...
System Diagram . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
ELECTRIC IGNITION SYSTEM . . . . . .
System Diagram . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
AIR CONDITIONING CUT CONTROL . . . ..
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . ..
Component Parts Location . . . . . . . . .
Component Description . . . . . . . . . . ...
AUTOMATIC SPEED CONTROL DEVICE
(ASCD) . . . . . . . . . . . . . . . ..
System Diagram . . . . . . . . . . . . . ..
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст