Nissan Tiida C11. Manual — part 774
EXL-94
< ON-VEHICLE REPAIR >
REAR COMBINATION LAMP
Hatchback
LKIA0760E
1.
Rear combination lamp harness
2.
Turn signal lamp bulb
3.
Back-up lamp bulb
4.
Stop/tail lamp bulb
5.
Rear combination lamp housing assembly
6.
Bumper stay
A.
Grommet
B.
Nut
C.
Clip
D.
Nuts
E.
Clip
REAR COMBINATION LAMP
EXL-95
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
Sedan
DISSASEMBLY
1.
Remove the rear combination lamp harness.
2.
Remove the bulbs from the rear combination lamp harness, as necessary.
3.
Remove the bumper stay (hatchback only).
4.
Remove the rear combination lamp seal (sedan only).
ASSEMBLY
Assembly is in the reverse order of disassembly.
ALLIA0316ZZ
1.
Rear combination lamp
2.
Back-up lamp bulb
3.
Turn signal lamp bulb
4.
Stop/tail lamp bulb
5.
Rear combination lamp harness
EXL-96
< ON-VEHICLE REPAIR >
HIGH-MOUNTED STOP LAMP
HIGH-MOUNTED STOP LAMP
Bulb Replacement
INFOID:0000000001530528
HATCHBACK
The LED element is not serviced separately, the high-mounted stop lamp must be replaced as an assembly.
SEDAN
1.
Open the luggage compartment lid to access the high-mounted stop lamp.
2.
Remove the high-mounted stop lamp bulb socket (1) and
remove the high-mounted stop lamp (2).
3.
Installation is in the reverse order of removal.
Removal and Installation
INFOID:0000000001530529
HATCHBACK
Removal
1.
Remove the rear hatch finish panel. Refer to
INT-18, "Removal and Installation"
2.
Disconnect the high-mounted stop lamp connector.
3.
Remove the high-mounted stop lamp nuts as shown.
4.
Remove the high-mounted stop lamp from the rear hatch.
Installation
Installation is in the reverse order of removal.
CAUTION:
Properly seal the high-mounted stop lamp base to the rear hatch to prevent water leaks.
SEDAN
Removal
1.
Open the luggage compartment lid to access the high-mounted stop lamp.
PKIC1021E
SKIB7594E
HIGH-MOUNTED STOP LAMP
EXL-97
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
2.
Remove the high-mounted stop lamp bulb socket (1) and
remove the high-mounted stop lamp (2).
3.
Remove the rear parcel shelf. Refer to
INT-26, "Removal and Installation"
4.
Remove the high-mounted stop lamp screws (A) and remove
the high-mounted stop lamp (1).
5.
Remove the high-mounted stop lamp finisher screws (A) and
remove the high-mounted stop lamp finisher (1).
Installation
Installation is in the reverse order of removal.
PKIC1021E
PKIC1022E
PKIC1023E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст