Nissan Tiida C11. Manual — part 769
EXL-74
< SYMPTOM DIAGNOSIS >
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Daytime light system does not activate.
• Either high beam bulb
• Parking brake switch
• Combination switch
• BCM
• IPDM E/R
• Daytime light relay
• Harness between IPDM E/R
and daytime light relay.
Daytime light system description.
Refer to
XX-XX, "*****"
.
Front fog lamp is not
turned ON.
One side
• Front fog lamp bulb
• Harness between IPDM E/R
and the front combination lamp
• Front combination lamp
• IPDM E/R
Front fog lamp circuit
Refer to
.
Both side
Symptom diagnosis
"BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON"
Refer to
Parking lamp is not turned
ON.
One side
• Fuse
• Parking lamp bulb
• Harness between IPDM E/R
and the front/rear combination
lamp
• Front/rear combination lamp
• IPDM E/R
Parking lamp circuit
Refer to
.
Both sides
Symptom diagnosis
"PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED
ON"
Refer to
Turn signal lamp does not
blink.
Indicator lamp is nor-
mal.
(The applicable side
performs the high flash-
er activation).
• Harness between BCM and
each turn signal lamp
• Turn signal lamp bulb
• Door mirror (if equipped with
turn signals in the door mirrors)
Turn signal lamp circuit
Refer to
.
Turn signal indicator lamp
does not blink.
One side
Combination meter
—
Both sides
(Always)
• Turn signal indicator lamp sig-
nal
• Combination meter
• BCM
• Combination meter.
Data monitor "TURN IND"
• BCM (FLASHER)
Active test "FLASHER"
Both sides
(Does blink when acti-
vating the hazard warn-
ing lamp with the
ignition switch OFF)
• The combination meter power
supply and the ground circuit
• Combination meter
Combination meter
Power supply and the ground circuit
Refer to
XX-XX, "*****"
.
Symptom
Possible cause
Inspection item
NORMAL OPERATING CONDITION
EXL-75
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
NORMAL OPERATING CONDITION
Description
INFOID:0000000001523288
AUTO LIGHT SYSTEM
The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright
area (short tunnel, sky bridge, shadowed area etc.). This is normal.
EXL-76
< SYMPTOM DIAGNOSIS >
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
Description
INFOID:0000000001523289
The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting.
Diagnosis Procedure
INFOID:0000000001523290
1.
COMBINATION SWITCH INSPECTION
Check the combination switch. Refer to
XX-XX, "*****"
.
Is the combination switch normal?
YES
>> GO TO 2
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select "HL HI REQ" of IPDM E/R DATA MONITOR item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3
NO
>> Replace BCM. Refer to
XX-XX, "*****"
.
3.
HEADLAMP (HI) CIRCUIT INSPECTION
Check the headlamp (HI) circuit. Refer to
EXL-33, "HEADLAMP (HALOGEN) : Description"
Is the headlamp (HI) circuit normal?
YES
>> Replace IPDM E/R. Refer to
XX-XX, "*****"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
ON
Except for HI or
PASS
OFF
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
EXL-77
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
Description
INFOID:0000000001523291
The headlamps (both sides) do not turn ON in any lighting switch setting.
Diagnosis Procedure
INFOID:0000000001523292
1.
CHECK COMBINATION SWITCH
Check the combination switch. Refer to
XX-XX, "*****"
.
Is the combination switch normal?
YES
>> GO TO 2
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select "HL LO REQ" of IPDM E/R DATA MONITOR item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3
NO
>> Replace BCM. Refer to
XX-XX, "*****"
.
3.
HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. Refer to
EXL-37, "HEADLAMP (HALOGEN) : Description"
.
Is the headlamp (LO) circuit normal?
YES
>> Replace IPDM E/R. Refer to
XX-XX, "*****"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
ON
OFF
OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст