Nissan Frontier D40. Manual — part 802
INSTRUMENT PANEL ASSEMBLY
IP-15
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
Installation
Installation is in the reverse order of removal.
M/T FINISHER
Removal
1.
Remove cup holder finisher.
2.
Rotate shift knob counterclockwise, then remove.
3.
Pull up to release clips, then remove the M/T finisher.
: Vehicle front
:Metal clip
Installation
Installation is in the reverse order of removal.
LOWER INSTRUMENT PANEL RH AND LOWER GLOVE BOX
Removal
1.
Remove front pillar lower finisher. Refer to
INT-18, "Removal and Installation"
.
2.
Remove lower instrument panel RH screws, using power tool.
3.
Remove lower instrument panel RH and lower glove box.
Installation
NOTE:
Install upper glove box before installing lower glove box.
Installation is in the reverse order of removal.
UPPER GLOVE BOX
Removal
1.
Remove lower instrument panel RH and lower glove box. Refer to LOWER INSTRUMENT PAHEL RH in
this section.
2.
Remove upper glove box lid screws, using power tool.
3.
Remove upper glove box.
Installation
Installation is in the reverse order of removal.
CENTER CONSOLE
Removal
ALJIA0461ZZ
IP-16
< ON-VEHICLE REPAIR >
INSTRUMENT PANEL ASSEMBLY
1.
Remove lower instrument panel RH and glove box. Refer to LOWER INSTRUMENT PANEL RH AND
GLOVE BOX in this section.
2.
Remove cup holder finisher.
3.
Remove A/T or M/T finisher. Refer to AT FINISHER or MT FINISHER in this section.
4.
Remove center console screws, then lift center console rear base away from center console front base
and disconnect harness connectors.
5.
Disconnect harness connectors, then remove center console front base.
Installation
Installation is in the reverse order of removal.
1.
Center console front base
2.
Center console rear base
Vehicle front
AWJIA0415ZZ
INSTRUMENT LOWER PANEL RH AND GLOVE BOX
IP-17
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
DISASSEMBLY AND ASSEMBLY
INSTRUMENT LOWER PANEL RH AND GLOVE BOX
Exploded View
INFOID:0000000005272875
Disassembly and Assembly
INFOID:0000000005272876
INSTRUMENT LOWER PANEL RH AND GLOVE BOX
Disassembly
1.
Remove fuse block cover.
2.
Remove damper hook.
3.
Remove lower glove box latch cover.
4.
Remove lower glove box latch assembly.
Assembly
Assembly is in the reverse order of disassembly.
UPPER GLOVE BOX
Disassembly
1.
Remove upper glove box lid screws.
2.
Remove upper glove box lid.
1.
Upper glove box
2.
Upper glove box lid
3.
Lower instrument panel RH
4.
Fuse block cover
5.
Lower glove box latch assembly cover 6.
Lower glove box
7.
Lower glove box latch assembly
8.
Damper hook
9.
Lower glove box damper
WIIA1049E
IP-18
< DISASSEMBLY AND ASSEMBLY >
INSTRUMENT LOWER PANEL RH AND GLOVE BOX
Assembly
Assembly is in the reverse order of disassembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст