Nissan Frontier D40. Manual — part 94
BRC-74
< BASIC INSPECTION >
[TYPE 2]
DIAGNOSIS AND REPAIR WORKFLOW
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
INFOID:0000000005548207
PRECAUTIONS FOR DIAGNOSIS
If steering angle sensor, steering system parts, suspension system parts, ABS actuator and electric unit (con-
trol unit) or tires have been replaced, or if wheel alignment has been adjusted, be sure to adjust neutral posi-
tion of steering angle sensor before driving. Refer to
BRC-78, "ADJUSTMENT OF STEERING ANGLE
DIAGNOSIS AND REPAIR WORKFLOW
BRC-75
< BASIC INSPECTION >
[TYPE 2]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
OVERALL SEQUENCE
DETAILED FLOW
1.
COLLECT THE INFORMATION FROM THE CUSTOMER
Get the detailed information from the customer about the symptom (the condition and the environment when
the incident/malfunction occurred) using the diagnosis worksheet. Refer to
BRC-77, "Diagnostic Work Sheet"
>> GO TO 2
JSFIA0010GB
BRC-76
< BASIC INSPECTION >
[TYPE 2]
DIAGNOSIS AND REPAIR WORKFLOW
2.
PERFORM THE SELF-DIAGNOSIS
Check the DTC display with the self-diagnosis function. Refer to
BRC-95, "CONSULT-III Function (ABS)"
Is there any DTC displayed?
YES
>> GO TO 3
NO
>> GO TO 4
3.
PERFORM THE SYSTEM DIAGNOSIS
Perform the diagnosis applicable to the displayed DTC. Refer to
.
>> GO TO 7
4.
CHECK THE SYMPTOM THAT IS NOT CONSIDERED A SYSTEM MALFUNCTION
Check that the symptom is a normal operation that is not considered a system malfunction. Refer to
Is the symptom a normal operation?
YES
>> Inspection End
NO
>> GO TO 5
5.
CHECK THE WARNING LAMP AND INDICATOR LAMP FOR ILLUMINATION
Check that the warning lamp and indicator lamp illuminate.
• ABS warning lamp: Refer to
.
• Brake warning lamp: Refer to
• VDC OFF indicator lamp: Refer to
• SLIP indicator lamp: Refer to
.
Is ON/OFF timing normal?
YES
>> GO TO 6
NO
>> GO TO 2
6.
PERFORM THE DIAGNOSIS BY SYMPTOM
Perform the diagnosis applicable to the symptom.
>> GO TO 7
7.
REPAIR OR REPLACE THE MALFUNCTIONING PARTS
Repair or replace the specified malfunctioning parts.
>> GO TO 8
8.
FINAL CHECK
Perform the self-diagnosis again, and check that the malfunction is repaired completely. After checking, erase
the self-diagnosis memory. Refer to
BRC-95, "CONSULT-III Function (ABS)"
.
Is no other DTC present and the repair completed?
YES
>> Inspection End
NO
>> GO TO 3
DIAGNOSIS AND REPAIR WORKFLOW
BRC-77
< BASIC INSPECTION >
[TYPE 2]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
Diagnostic Work Sheet
INFOID:0000000005548208
SFIA3265E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст