Nissan Frontier D40. Manual — part 920
PWC-62
< SYMPTOM DIAGNOSIS >
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPERATE
PROPERLY
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPER-
ATE PROPERLY
Diagnosis Procedure
INFOID:0000000005274660
1.
CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to
DLK-29, "CREW CAB : Component Function Check"
or
.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Check intermittent incident. Refer to
GI-46, "Intermittent Incident"
.
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
PWC-63
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
Diagnosis Procedure
INFOID:0000000005274661
1.
REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch and check operation.
Refer to
PWC-65, "Removal and Installation"
.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> Check intermittent incident. Refer to
GI-46, "Intermittent Incident"
.
PWC-64
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000005550755
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery, and wait at least 3 minutes before performing any service.
POWER WINDOW MAIN SWITCH
PWC-65
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
ON-VEHICLE REPAIR
POWER WINDOW MAIN SWITCH
Removal and Installation
INFOID:0000000005274663
REMOVAL
1.
Remove the power window main switch finisher (2) from the
front door finisher LH. Refer to
INT-14, "Removal and Installa-
: Metal clip
:Pawl
2.
Remove the three screws (A) from the power window main
switch (1), then separate from the finisher (2).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA1097ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст