Nissan Frontier. Manual — part 1317
WT-16
< DTC/CIRCUIT DIAGNOSIS >
C1708 - C1711 DATA FROM TRANSMITTER NOT BEING RECEIVED
NO
>> Replace BCM, then GO TO 3. Refer to
BCS-49, "Removal and Installation"
3.
PERFORM ID REGISTRATION
Carry out ID registration of all transmitters. Refer to
.
Is there a tire that cannot register ID?
YES
>> Replace malfunctioning transmitter, then GO TO 5. Refer to
WT-50, "Transmitter (Pressure Sen-
NO
>> GO TO 4
4.
DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT within 15 minutes after vehicle speed becomes 17 km/h (11
MPH).
Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
YES
>> Inspection End.
NO
>> GO TO 5
5.
ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. Refer to
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
3. Check all tire pressures with CONSULT within 5 minutes.
Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
YES
>> Inspection End.
NO
>> Proceed to the inspection applicable to DTC.
Special Repair Requirement
INFOID:0000000009480252
Perform preliminary check. Refer to
.
C1712 - C1715, C1720 - C1723, C1724 - C1727 TRANSMITTER MALFUNCTION
WT-17
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
C1712 - C1715, C1720 - C1723, C1724 - C1727 TRANSMITTER MALFUNC-
TION
Description
INFOID:0000000009480253
One or more transmitters are malfunctioning internally.
DTC Logic
INFOID:0000000009480254
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
2. Check all tire pressures with CONSULT within 5 minutes.
Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
YES
>> Inspection End.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000009480255
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
MALFUNCTION CODE NO. 31, 32, 33, 34, 41, 42, 43, 44, 45, 46, 47 OR 48 (DTC C1712, C1713,
C1714, C1715, C1720, C1721, C1722, C1723, C1724, C1725, C1726 OR C1727)
1.
PERFORM ID REGISTRATION
DTC
CONSULT
DTC detecting condition
C1712
[CHECKSUM - ERR] - FL
Checksum data from FL transmitter is malfunctioning.
C1713
[CHECKSUM - ERR] - FR
Checksum data from FR transmitter is malfunctioning.
C1714
[CHECKSUM - ERR] - RR
Checksum data from RR transmitter is malfunctioning.
C1715
[CHECKSUM - ERR] - RL
Checksum data from RL transmitter is malfunctioning.
C1720
[CODE - ERR] - FL
Function code data from FL transmitter is malfunctioning.
C1721
[CODE - ERR] - FR
Function code data from FR transmitter is malfunctioning.
C1722
[CODE - ERR] - RR
Function code data from RR transmitter is malfunctioning.
C1723
[CODE - ERR] - RL
Function code data from RL transmitter is malfunctioning.
C1724
[BATT - VOLT - LOW] - FL
Battery voltage of FL transmitter drops.
C1725
[BATT - VOLT - LOW] - FR
Battery voltage of FR transmitter drops.
C1726
[BATT - VOLT - LOW] - RR
Battery voltage of RR transmitter drops.
C1727
[BATT - VOLT - LOW] - RL
Battery voltage of RL transmitter drops.
WT-18
< DTC/CIRCUIT DIAGNOSIS >
C1712 - C1715, C1720 - C1723, C1724 - C1727 TRANSMITTER MALFUNCTION
1. Carry out ID registration of all transmitters. Refer to
.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
>> GO TO 2
2.
REPLACE TRANSMITTER
1. Check low tire pressure warning lamp again for flashing, replace malfunctioning transmitter. Refer to
50, "Transmitter (Pressure Sensor)"
2. Carry out ID registration of all transmitters. Refer to
Can ID registration of all transmitters be completed?
YES
>> GO TO 3
NO
>> GO TO
3.
DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
2. Check all tire pressures with CONSULT within 5 minutes.
Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
YES
>> Inspection End.
NO
>> Replace malfunctioning transmitter, and perform Step 3 again.
Special Repair Requirement
INFOID:0000000009480256
Perform preliminary check. Refer to
.
C1716 - C1719 TRANSMITTER PRESSURE MALFUNCTION
WT-19
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
C1716 - C1719 TRANSMITTER PRESSURE MALFUNCTION
Description
INFOID:0000000009480257
Air pressure data from one or more transmitters is out of range.
DTC Logic
INFOID:0000000009480258
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. Refer to
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
3. Check all tire pressures with CONSULT within 5 minutes.
Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
YES
>> Inspection End.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000009480259
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
MALFUNCTION CODE NO. 35, 36, 37 OR 38 (DTC C1716, C1717, C1718 OR C1719)
1.
CHECK ALL TIRE PRESSURES
Check all tire pressures. Refer to
Are there any tires with pressure of 64 psi or more?
YES
>> Adjust tire pressure to specified value.
NO
>> GO TO 2
2.
ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. Refer to
2. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
3. Check all tire pressures with CONSULT within 15 minutes after vehicle speed becomes 17 km/h (11
MPH).
Does DATA MONITOR ITEM display 64 psi or more?
DTC
CONSULT
DTC detecting condition
C1716
[PRESSDATA - ERR] FL
Air pressure data from FL transmitter is malfunctioning.
C1717
[PRESSDATA - ERR] FR
Air pressure data from FR transmitter is malfunctioning.
C1718
[PRESSDATA - ERR] RR
Air pressure data from RR transmitter is malfunctioning.
C1719
[PRESSDATA - ERR] RL
Air pressure data from RL transmitter is malfunctioning.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст