Nissan Sentra. Manual — part 613
HEADLINING
INT-41
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
Rotate 90
° and remove as shown.
14. Remove headlining clips.
15. Remove headlining from roof panel as shown. Adjust the posi-
tion of headlining so that it can be removed through passenger
side door.
16. Remove headlining as shown.
CAUTION:
• Two people are required for removal in order to prevent
damage.
• Do not bend headlining when removing.
• Be careful not to scratch or damage any part of the body
while removing the headliner.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• When installing headlining, start by installing both sun visor holders and the headlining clips in
order to keep the headlining in position.
• Do not bend headlining when installing.
• Be careful that the surface is not wrinkled when installing.
• When installing assist grip, install metal clip (1) to assist grip
clip (2), then install to the body panel.
JMJIA4401ZZ
JMJIA7803ZZ
JMJIA7804ZZ
JMJIA3623ZZ
INT-42
< REMOVAL AND INSTALLATION >
TRUNK ROOM TRIM
TRUNK ROOM TRIM
Exploded View
INFOID:0000000009756923
TRUNK REAR PLATE
TRUNK REAR PLATE : Removal and Installation
INFOID:0000000009756924
REMOVAL
1. Remove trunk floor trim.
1.
Trunk floor trim
2.
Trunk front floor spacer (LH)
3.
Trunk side finisher (LH)
4.
Reflector box assembly
*
5.
Trunk rear plate
6.
Trunk side finisher (RH)
7.
Trunk front floor spacer (RH)
Clip
Pawl
ALJIA1136ZZ
TRUNK ROOM TRIM
INT-43
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
2. Remove clips (A).
3. Release trunk rear plate pawls as shown.
: Pawl
4. Remove trunk rear plate.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When installing, check that clips and pawls are accurately aligned with the holes on body panel, then
press in.
TRUNK SIDE FINISHER
TRUNK SIDE FINISHER : Removal and Installation
INFOID:0000000009756925
REMOVAL
1. Remove trunk rear plate. Refer to
INT-42, "TRUNK REAR PLATE : Removal and Installation"
.
2. Apply protective tape (A) to protect the component from damage
as shown.
JMJIA6085ZZ
ALJIA1137ZZ
JMJIA7806ZZ
INT-44
< REMOVAL AND INSTALLATION >
TRUNK ROOM TRIM
3. Release trunk side finisher clips using a suitable tool (A).
: Clip
4. Remove trunk side finisher clips (A) and the trunk side finisher (1).
: Clip
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Insert rear end of trunk side finisher into trunk weather strip.
• When installing, check that clips are accurately aligned with the holes on body panel, then press in.
ALJIA1138ZZ
ALJIA1125ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст