Nissan Sentra. Manual — part 489
EXT-24
< REMOVAL AND INSTALLATION >
FRONT GRILLE
2. Apply protective tape (A) to protect the components from dam-
age.
3. Remove the front grille clips (A).
4. Release pawls from back side while pulling front grille toward
vehicle front and remove front grille.
: Pawl
5. Remove emblem from front grille (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
JMKIB0243ZZ
AWKIA2114ZZ
AWKIA2115ZZ
COWL TOP
EXT-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
COWL TOP
Exploded View
INFOID:0000000009758038
1.
Cowl top seal
2.
Cowl top grille cap
3.
Cowl top cover
4.
Cowl top extension
5.
Cowl top extension insulator
6.
Clip
JMKIB0365ZZ
EXT-26
< REMOVAL AND INSTALLATION >
COWL TOP
Removal and Installation
INFOID:0000000009758039
COWL TOP COVER
Removal
1. Remove front wiper arms (LH/RH). Refer to
WW-57, "Removal and Installation"
2. Remove front fender covers (LH/RH). Refer to
.
3. Remove front fender seals (LH/RH). Refer to
.
4. Remove cowl top cover clips.
5. Pull forward to release cowl top cover from windshield glass.
CAUTION:
When performing the procedure after removing cowl top
cover, cover the lower end of windshield glass with ure-
thane etc.
6. Remove cowl top cover.
7. Remove the following from the cowl top cover.
• EPT sealer
• Cowl top seal
• Cowl top grille cap
Installation
Installation is in the reverse order of removal.
CAUTION:
• Clean the joint between the cowl top cover and the windshield.
• Replace the EPT sealer on the back surface with new EPT sealer when reusing the cowl top cover.
• Remove the EPT sealer remaining on the cowl top cover using a double-faced adhesive tape remove.
• To maintain adhesion, do not wash the vehicle within 24 hours after installation.
• Perform the stop position adjustment at the installation of the front wiper arms.
Cowl Top Extension
Removal
1. Remove the cowl top cover.
2. Remove front wiper drive assembly. Refer to
WW-62, "Removal and Installation"
3. Remove cowl top extension bolts and cowl top extension.
4. Remove cowl top extension insulator clips and cowl top extension insulator.
Installation
Installation is in the reverse order of removal.
7.
EPT seal [t: 3.0 mm (0.12 in)
8.
Cowl top cover cap
9.
EPT seal [t: 5.0 mm (0.20 in)]
Pawl
Clip
Front
JMKIA3819ZZ
FENDER PROTECTOR
EXT-27
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FENDER PROTECTOR
FENDER PROTECTOR
FENDER PROTECTOR : Exploded View
INFOID:0000000009758040
AWKIA2120ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст