Nissan Sentra. Manual — part 306
DLK-340
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
2. Insert a suitable tool (A) as shown into bottom of fuel filler lock
assembly(1).
3. Release upper and lower pawls (A) using a suitable tool and
remove fuel filler lid lock assembly (1).
CAUTION:
Be careful not to damage gasket (2) when removing.
4. Disconnect fuel filler lid opener cable (1) by pulling downward
and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
ALKIA2731ZZ
JMKIA8138ZZ
JMKIA8139ZZ
DOOR SWITCH
DLK-341
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DOOR SWITCH
Removal and Installation
INFOID:0000000009756659
REMOVAL
1. Remove the door switch bolt (A).
2. Disconnect the harness connector from the door switch (1) and
remove.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2509ZZ
ALKIA2930ZZ
DLK-342
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
REMOTE KEYLESS ENTRY RECEIVER
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
INFOID:0000000009756660
REMOVAL
1. Remove glove box assembly. Refer to
IP-22, "Removal and Installation"
2. Disconnect the harness connector from the remote keyless entry receiver.
3. Remove the screw and remote keyless entry receiver.
INSTALLATION
Installation is in the reverse order or removal.
KEYFOB BATTERY
DLK-343
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
KEYFOB BATTERY
Exploded View
INFOID:0000000009756661
Removal and Installation
INFOID:0000000009756662
REMOVAL
1. Remove the keyfob screw.
2. Seperate the upper and lower case using a suitable tool.
CAUTION:
• Do not touch the circuit board or battery terminal.
• The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
3. Remove the circuit board from the upper case.
CAUTION:
Do not touch the printed circuits directly.
4. Remove the keyfob battery from the upper case.
CAUTION:
• When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact
area.
• After replacing the battery, Be sure to check that door locking operates normally using the key-
fob.
INSTALLATION
Installation is in the reverse order of removal.
1.
Upper case
2.
Key
3.
Switch cover
4.
Switch rubber
5.
Board surface
6.
Battery
7.
Plate
8.
Lower case
9.
Screw
JMKIA1442ZZ
Battery replacement
: Coin-type lithium battery (CR1620)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст