Nissan Sentra. Manual — part 302
DLK-324
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
DOOR HANDLE
4. Remove door side grommet, and loosen screw that retains the
rear door outside handle bracket.
5. While pulling outside handle (1), remove outside handle
escutcheon (2).
6. While pulling outside handle (1), slide toward rear of vehicle to
remove outside handle.
7. Remove front gasket (1) and rear gasket (2).
: Front
8. Slide outside handle bracket toward rear of vehicle to remove.
: Front
JMKIA1467ZZ
JMKIA5342ZZ
AWKIA1997ZZ
JMKIA5889ZZ
JMKIA5890ZZ
DOOR HANDLE
DLK-325
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
9. Remove clip and disconnect the outside handle cable from the
outside handle bracket.
INSTALLATION
Installation in the reverse order of removal.
CAUTION:
• When installing do not reuse rear door outside handle bracket screw. Always replace screw with new
ones when removed.
• Check rear door lock cable is properly engaged to outside handle bracket.
• After installation, check rear door open/close, lock/unlock operation.
PIIB5815E
DLK-326
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
DOOR LOCK
DOOR LOCK
FRONT DOOR LOCK
FRONT DOOR LOCK : Exploded View
INFOID:0000000009756642
FRONT DOOR LOCK : Removal and Installation
INFOID:0000000009756643
CAUTION:
Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three
minutes.
REMOVAL
1. Remove the front door outside handle. Refer to
DLK-173, "FRONT DOOR HANDLE : Removal and Instal-
.
2. Remove the rear glass run.
3. Disconnect the harness connector from the front door lock actuator.
1.
Outside handle bracket
2.
Front gasket
3.
Outside handle
4.
Door lock assembly
5.
Door striker
6.
Door key cylinder rod
7.
Inside handle assembly
8.
Outside handle escutcheon
9.
Rear gasket
ALKIA2939ZZ
DOOR LOCK
DLK-327
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
4. Remove screws, and the door lock assembly.
INSTALLATION
Installation is in the reverse order of removal.
Tighten front door lock screws to specified torque.
CAUTION:
• Do not reuse front door lock assembly screws. Always replace screws with new ones when
removed.
• Check front door lock cables are properly engaged to inside handle and outside handle bracket.
• When installing door key cylinder rod on the LH front door, be sure to rotate door key cylinder rod
holder until a click is felt.
• After installation, check front door open/close, lock/unlock operation.
• Check front door lock assembly for poor lubrication. If necessary apply a suitable multi-purpose
grease.
REAR DOOR LOCK
PIIB5812E
Front door lock screws:
5.8 N·m (0.59 kg-m, 51 in-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст