Nissan Sentra. Manual — part 929
WT-18
< WIRING DIAGRAM >
TIRE PRESSURE MONITORING SYSTEM
WITHOUT INTELLIGENT KEY : Wiring Diagram
INFOID:0000000009758141
ABEWA0110GB
TIRE PRESSURE MONITORING SYSTEM
WT-19
< WIRING DIAGRAM >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
ABEIA0252GB
WT-20
< WIRING DIAGRAM >
TIRE PRESSURE MONITORING SYSTEM
ABEIA0253GB
DIAGNOSIS AND REPAIR WORK FLOW
WT-21
< BASIC INSPECTION >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000009758142
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
• Activate and display TPMS transmitter IDs
• Display tire pressure reported by the TPMS transmitter
• Read TPMS DTCs
• Register TPMS transmitter IDs
1.
COLLECT INFORMATION FROM CUSTOMER
Get detailed information from the customer about the symptom (the condition and the environment when the
incident/malfunction occurred).
>> GO TO 2.
2.
TIRE PRESSURE INSPECTION
Check the tire pressure for all wheels. Refer to
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace tire(s) or wheel(s).
3.
CHECK LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp illuminates for approximately 1 second after the ignition switch
is turned ON, then turns OFF.
Does the low tire pressure warning lamp turn OFF?
YES
>> Inspection End.
NO
>> GO TO 4.
4.
PERFORM SELF DIAGNOSTIC RESULT
Perform self diagnostic result. Refer to
WT-11, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR
(with Intelligent Key system) or
WT-13, "AIR PRESSURE MONITOR : CONSULT
Function (BCM - AIR PRESSURE MONITOR)"
(without Intelligent Key system).
Are any DTCs displayed?
YES
>> Refer to
(with Intelligent Key system) or
Intelligent Key system). If two or more DTCs are displayed, refer to
"DTC Inspection Priority Chart"
(with Intelligent Key system) or
"DTC Inspection Priority Chart"
(without Intelligent Key system).
NO
>> GO TO 5.
5.
PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM
Perform diagnosis applicable to the symptom. Refer to
>> GO TO 6.
6.
FINAL CHECK
Perform self diagnostic result again, and check that the malfunction is repaired. After checking, erase the self
diagnosis memory. Refer to
WT-11, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRES-
(with Intelligent Key system) or
WT-13, "AIR PRESSURE MONITOR : CONSULT Function
(without Intelligent Key system).
>> Inspection End.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст