Nissan Cube. Manual — part 1034
C1704, C1705, C1706, C1707 LOW TIRE PRESSURE
WT-27
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
CAUTION:
Stop the vehicle and within 5 minutes, use “DATA MONITOR” in “AIR PRESSURE MONITOR” of “BCM”
to display the tire pressure for all wheels.
Is the inspection result normal?
YES
>> Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
NO
>> GO TO 1.
Special Repair Requirement
INFOID:0000000009949860
1.
CHECK TIRE PRESSURE
Check all tires for tire pressures. Refer to
.
Does all tire pressure data meet the specification?
YES
>> GO TO 2.
NO
>> Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
2.
PERFORM ID REGISTRATION
Perform ID registration. Refer to
.
>> END
Monitor item
Condition
Displayed value
AIR PRESS FL
Drive for 3 minutes at a speed of 40 km/h (25 MPH) or
more, then drive normally for 10 minutes.
Internal pressure of tires
AIR PRESS FR
AIR PRESS RR
AIR PRESS RL
WT-28
< DTC/CIRCUIT DIAGNOSIS >
C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR
C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR
DTC Logic
INFOID:0000000009949861
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to
.
>> GO TO 2.
2.
PERFORM DTC CONFIRMATION
With CONSULT
1.
Drive the vehicle at 40 km/h or more for 10 minutes.
CAUTION:
Total time driving at a speed of 40 km/h or more must be 10 minutes.
NOTE:
Avoid driving in area where radio wave cannot be transmitted/received.
2.
Stop the vehicle.
3.
Perform self-diagnosis for “AIR PRESSURE MONITOR” of “BCM”.
Is DTC “C1708”, “C1709”, “C1710” or “C1711” detected?
YES
>> Proceed to
.
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000009949862
1.
CHECK TIRE PRESSURE SIGNAL
With CONSULT
1.
Select “DATA MONITOR” in “AIR PRESSURE MONITOR” of “BCM”.
2.
Check the values that are displayed for “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR”, and “AIR
PRESS RL”.
Are all tire pressures displayed 0 kPa (psi)?
YES (With intelligent key system)>>GO TO 2.
YES (Without intelligent key system)>>GO TO 4.
NO
>> Replace applicable tire pressure sensor. Refer to
WT-48, "WITH INTELLIGENT KEY : Removal
(With intelligent key system),
WT-51, "WITHOUT INTELLIGENT KEY : Removal
(Without intelligent key system).
2.
CHECK RECEIVER CIRCUIT
1.
Turn the ignition switch OFF.
2.
Check 10A fuse (#13).
CAUTION:
Check that the fuse is not blown, that there are no other abnormalities, and that the fuse is of the
specified capacity.
3.
Disconnect BCM harness connector and tire pressure receiver harness connector.
DTC
Display Item
Malfunction detected condition
Possible causes
C1708
[NO DATA] FL
Tire pressure data signal from the front LH wheel
tire pressure sensor cannot be detected.
• Harness or connector
(Tire pressure receiver, BCM)
• Tire pressure sensor ID regis-
tration incomplete
• Tire pressure sensor
• Tire pressure sensor battery
voltage
• Driving in area where radio
wave cannot be transmitted/re-
ceived.
C1709
[NO DATA] FR
Tire pressure data signal from the front RH wheel
tire pressure sensor cannot be detected.
C1710
[NO DATA] RR
Tire pressure data signal from the rear RH wheel
tire pressure sensor cannot be detected.
C1711
[NO DATA] RL
Tire pressure data signal from the rear LH wheel
tire pressure sensor cannot be detected.
C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR
WT-29
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
4.
Check the continuity between BCM harness connector and tire pressure receiver harness connector.
5.
Check the continuity between BCM harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace error-detected parts.
3.
CHECK TIRE PRESSURE RECEIVER POWER SUPPLY CIRCUIT
1.
Connect tire pressure receiver harness connector.
2.
Check the voltage between tire pressure receiver harness connector and the ground when the ignition
switch is turned ON and OFF.
CAUTION:
Never start the engine.
Is the inspection result normal?
YES
>> GO TO 6.
NO
>> Repair or replace error-detected parts.
4.
CHECK RECEIVER CIRCUIT
1.
Turn the ignition switch OFF.
2.
Disconnect BCM harness connector and tire pressure receiver harness connector.
3.
Check the continuity between BCM harness connector and tire pressure receiver harness connector.
4.
Check the continuity between BCM harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Repair or replace error-detected parts.
5.
CHECK TIRE PRESSURE RECEIVER POWER SUPPLY CIRCUIT
BCM
Tire pressure receiver
Continuity
Connector
Terminal
Connector
Terminal
M68
18
M87
4
Existed
38
2
BCM
—
Continuity
Connector
Terminal
M68
18
Ground
Not existed
38
Tire pressure receiver
—
Voltage
Connector
Terminal
M87
1
Ground
9 – 16 V
BCM
Tire pressure receiver
Continuity
Connector
Terminal
Connector
Terminal
M65
18
M61
1
Existed
19
4
20
2
BCM
—
Continuity
Connector
Terminal
M65
18
Ground
Not existed
19
20
WT-30
< DTC/CIRCUIT DIAGNOSIS >
C1708, C1709, C1710, C1711 TIRE PRESSURE SENSOR
1.
Connect tire pressure receiver harness connector.
2.
Check the voltage between tire pressure receiver harness connector and the ground when the ignition
switch is turned ON and OFF.
CAUTION:
Never start the engine.
Is the inspection result normal?
YES
>> GO TO 6.
NO
>> Replace the BCM.
6.
CHECK TIRE PRESSURE SIGNAL
Check the function tire pressure receiver. Refer to
DLK-75, "Component Function Check"
(With intelligent
key system),
DLK-280, "Wiring Diagram - REMOTE KEYLESS ENTRY SYSTEM -"
(Without intelligent key
system).
Is the inspection result normal?
YES
>> Replace the BCM.
NO
>> Repair or replace error-detected parts.
Special Repair Requirement
INFOID:0000000009949863
1.
CHECK TIRE PRESSURE
Check all tires for tire pressures. Refer to
.
Does all tire pressure data meet the specification?
YES
>> GO TO 2.
NO
>> Inspect or repair the tires or wheels and adjust the tire pressure to the specification.
2.
PERFORM ID REGISTRATION
Perform ID registration. Refer to
.
>> END
Tire pressure receiver
—
Voltage
Connector
Terminal
M61
1
Ground
9 – 16 V
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст