Nissan Cube. Manual — part 476
EXL-178
< SYMPTOM DIAGNOSIS >
EXTERIOR LIGHTING SYSTEM SYMPTOMS
SYMPTOM DIAGNOSIS
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000009945193
NOTE:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any
DTC is detected.
Symptom
Possible cause
Inspection item
Headlamp (HI) is not
turned ON.
One side
• Fuse
• Halogen bulb (HI)
• Harness between IPDM E/R and the
headlamp
• Harness between headlamp and the
ground
• IPDM E/R
Headlamp (HI) circuit
Refer to
.
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON”
Refer to
.
High beam indicator lamp is not turned ON.
[Headlamp (HI) is turned ON.]
Combination meter
• Combination meter
Data monitor “HI-BEAM IND”
• BCM (HEADLAMP)
Active test “HEADLAMP”
Headlamp (LO) is not
turned ON.
One side
• Fuse
• Halogen bulb (LO)
• Harness between IPDM E/R and the
headlamp
• Harness between headlamp and the
ground
• IPDM E/R
Headlamp (LO) circuit
Refer to
.
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON”
Refer to
.
Headlamp is not turned
OFF.
When ignition switch is
turned ON.
When ignition switch is
turned OFF.
IPDM E/R
—
Headlamp is not turned ON/OFF with the lighting
switch AUTO.
• Combination switch
• Harness between the combination
switch and BCM
• BCM
Combination switch
Refer to
.
• Optical sensor
• Harness between the optical sensor
and BCM
• BCM
Optical sensor
Refer to
.
Front fog lamp is not
turned ON.
One side
• Front fog lamp bulb
• Harness between IPDM E/R and the
front fog lamp
• Front fog lamp
• IPDM E/R
Front fog lamp circuit
Refer to
.
Both side
Symptom diagnosis
“BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON”
Refer to
.
Front fog lamp is not turned ON.
Parking lamp is not turned ON.
• Parking lamp bulb
• Harness between IPDM E/R and the
parking lamp
• Front combination lamp assembly
• IPDM E/R
Parking lamp circuit
Refer to
.
EXTERIOR LIGHTING SYSTEM SYMPTOMS
EXL-179
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
Tail lamp is not turned ON.
• Tail lamp bulb
• Harness between IPDM E/R and the
rear combination lamp
• Rear combination lamp assembly
Tail lamp circuit
Refer to
.
Rear side marker lamp is not turned ON.
• Rear side marker lamp bulb
• Harness between IPDM E/R and the
rear side marker lamp
• Rear side marker lamp assembly
Rear side marker lamp circuit
Refer to
.
License plate lamp is not turned ON.
• License plate lamp bulb
• Harness between IPDM E/R and the
license plate lamp
• License plate lamp assembly
License plate lamp circuit
Refer to
.
• Parking lamp, tail lamp, rear side marker lamp and
license plate lamp are not turned ON.
• Parking lamp, tail lamp, rear side marker lamp and
license plate lamp are not turned OFF.
(Each illumination is turned ON/OFF.)
Symptom diagnosis
“PARKING, LICENSE PLATE, SIDE MARKER AND TAIL LAMPS ARE NOT
TURNED ON”
Refer to
.
Tail lamp indicator is not turned ON.
(Parking and tail lamps are turned ON.)
Combination meter
• Combination meter
Data monitor “LIGHT IND”
• BCM (HEADLAMP)
Active test “TAIL LAMP”
Turn signal lamp does not
blink.
Indicator lamp is nor-
mal.
(Applicable side per-
forms the high flasher
activation.)
• Harness between BCM and each
turn signal lamp
• Turn signal lamp bulb
Turn signal circuit
Refer to
.
Indicator lamp is includ-
ed.
• Combination switch
• Harness between the combination
switch and BCM
• BCM
Combination switch
Refer to
(with Intelligent Key)
(without Intelligent Key).
Turn signal indicator lamp
does not blink.
(Turn signal lamp is nor-
mal.)
One side
Combination meter
—
Both sides
(Always)
• Turn signal indicator lamp signal
- BCM
• Combination meter
• Combination meter
Data monitor “TURN IND”
• BCM (FLASHER)
Active test “FLASHER”
Both sides
(Only when activating
hazard warning lamp
with the ignition switch
OFF.)
• Combination meter power supply
and the ground circuit
• Combination meter
Combination meter
Power supply and the ground circuit
Refer to
.
• Hazard warning lamp does not activate.
• Hazard warning lamp continues activating.
(Turn signal is normal.)
• Hazard switch
• Harness between the hazard switch
and BCM
• BCM
Hazard switch
Refer to
.
Symptom
Possible cause
Inspection item
EXL-180
< SYMPTOM DIAGNOSIS >
NORMAL OPERATING CONDITION
NORMAL OPERATING CONDITION
Description
INFOID:0000000009945195
AUTO LIGHT SYSTEM
The headlamp may not be turned ON/OFF immediately after passing dark area or bright area (short tunnel,
sky bridge, shadowed area etc.) while using the auto light system. This causes the control difference. This is
normal.
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
EXL-181
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
Description
INFOID:0000000009945196
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
Diagnosis Procedure
INFOID:0000000009945197
1.
COMBINATION SWITCH INSPECTION
Check the combination switch. Refer to
(with Intelligent Key) or
Is the combination switch normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT DATA MONITOR
1.
Select “HL HI REQ” of IPDM E/R data monitor item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-88, "Removal and Installation"
(with Intelligent Key) or
(without Intelligent Key).
3.
HEADLAMP (HI) CIRCUIT INSPECTION
Check the headlamp (HI) circuit. Refer to
EXL-42, "Component Function Check"
Is the headlamp (HI) circuit normal?
YES
>> Replace IPDM E/R.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
ON
LO
OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст