Nissan Juke F15. Manual — part 1172
B0029 CURTAIN AIR BAG MODULE
SRC-53
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
• Never use unspecified tester or other measuring device.
1.
CHECK HARNESS CONNECTOR
Check the harness connector for disconnection, looseness or damage.
Is the inspection result normal?
YES
>> GO TO 2.
NO–1 >> Damage: Replace malfunctioning harness and connector.
NO–2 >> Disconnection or looseness: Securely lock the connector.
2.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Replace malfunctioning harness and connector.
3.
REPLACE CURTAIN AIR BAG MODULE RH
1. Replace curtain air bag module RH. Refer to
SR-21, "Removal and Installation"
.
2. Perform DTC confirmation procedure. Refer to
.
Is DTC detected?
YES
>> GO TO 4.
NO
>> INSPECTION END
4.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
1. Replace air bag diagnosis sensor unit. Refer to
SR-29, "Removal and Installation"
2. Perform DTC confirmation procedure. Refer to
.
Is DTC detected?
YES
>> GO TO 1.
NO
>> INSPECTION END
SRC-54
< DTC/CIRCUIT DIAGNOSIS >
B0091 B-PILLAR SATELLITE SENSOR
B0091 B-PILLAR SATELLITE SENSOR
DTC Description
INFOID:0000000012199606
DTC DETECTION LOGIC
POSSIBLE CAUSE
[B0091–11]
• Connection malfunction or short circuit to ground of harness and connector
• Internal malfunction of satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0091–23, B0091–24, B0091–25, B0091–28]
• Internal malfunction of satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0091–81, B0091–93]
• Connection malfunction of harness or connector
• Internal malfunction of satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0091–86]
• Air bag diagnosis sensor unit and satellite sensor LH is different from the part specified
[B0091–88]
• Connection malfunction or open circuit of harness and connector
• Internal malfunction of satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
1.
CHECK SELF-DIAG RESULT
With CONSULT
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.
Without CONSULT
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to
SRC-10, "On Board Diagnosis Function"
NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected?
YES
>> Refer to
NO-1 >> To check malfunction symptom before repair: Refer to
GI-45, "Intermittent Incident"
.
DTC
CONSULT screen items
(Trouble diagnosis content)
DTC detecting condition
B0091–11
B-PILLAR SAT SEN LH
[Left Side Restraints
Sensor 1 (Subfault)]
[GND-SHORT]
Satellite sensor LH circuit is shorted to ground
B0091–23
[LOWER LIMIT ERR]
Lower limit value malfunction of satellite sensor LH
B0091–24
[UPPER LIMIT ERR]
Upper limit value malfunction of satellite sensor LH
B0091–25
[SELF-DIAG ERR]
Diagnosis malfunction of satellite sensor LH
B0091–28
[OFFSET ERR]
Offset malfunction of satellite sensor LH
B0091–81
[COMM ERR]
Communication malfunction of satellite sensor LH
B0091–86
[UNMATCH]
Satellite sensor LH is out of the specified specification
B0091–88
[OPEN]
Satellite sensor LH circuit is open
B0091–93
[RESET]
Reset malfunction of satellite sensor LH
B0091 B-PILLAR SATELLITE SENSOR
SRC-55
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
NO-2 >> Confirmation after repair: INSPECTION END
Diagnosis Procedure
INFOID:0000000012199607
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3
minutes or more. (To discharge backup capacitor.)
• Never use unspecified tester or other measuring device.
1.
CHECK DTC
Perform each inspection according to the displayed DTC.
Which DTC is displayed?
[B0091–86]>>GO TO 4.
Other than the above>>GO TO 2.
2.
CHECK HARNESS CONNECTOR
Check the harness connector for disconnection, looseness or damage.
Is the inspection result normal?
YES
>> GO TO 3.
NO–1 >> Damage: Replace malfunctioning harness and connector.
NO–2 >> Disconnection or looseness: Securely lock the connector.
3.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Replace malfunctioning harness and connector.
4.
REPLACE SATELLITE SENSOR LH
1. Replace satellite sensor LH. Refer to
SR-26, "Removal and Installation"
.
2. Perform DTC confirmation procedure. Refer to
.
Is DTC detected?
YES
>> GO TO 5.
NO
>> INSPECTION END
5.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
1. Replace air bag diagnosis sensor unit. Refer to
SR-29, "Removal and Installation"
2. Perform DTC confirmation procedure. Refer to
.
Is DTC detected?
YES
>> GO TO 1.
NO
>> INSPECTION END
SRC-56
< DTC/CIRCUIT DIAGNOSIS >
B0093 FRONT DOOR SATELLITE SENSOR LH
B0093 FRONT DOOR SATELLITE SENSOR LH
DTC Description
INFOID:0000000012199608
DTC DETECTION LOGIC
POSSIBLE CAUSE
[B0093–11]
• Connection malfunction or short circuit to ground of harness and connector
• Internal malfunction of front door satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0093–23, B0093–24, B0093–25, B0093–28]
• Internal malfunction of front door satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0093–81, B0093–93]
• Connection malfunction of harness or connector
• Internal malfunction of front door satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
[B0093–86]
• Air bag diagnosis sensor unit and front door satellite sensor LH is different from the part specified
[B0093–88]
• Connection malfunction or open circuit of harness and connector
• Internal malfunction of front door satellite sensor LH
• Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
1.
CHECK SELF-DIAG RESULT
With CONSULT
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.
Without CONSULT
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to
SRC-10, "On Board Diagnosis Function"
NOTE:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected?
YES
>> Refer to
NO-1 >> To check malfunction symptom before repair: Refer to
GI-45, "Intermittent Incident"
.
DTC
CONSULT screen items
(Trouble diagnosis content)
DTC detecting condition
B0093–11
DOOR SATEL SENS LH
[Left Side Restraints Sen-
sor 3 (Subfault)]
[GND-SHORT]
Front door satellite sensor LH circuit is shorted to ground
B0093–23
[LOWER LIMIT ERR] Lower limit value malfunction of front door satellite sensor LH
B0093–24
[UPPER LIMIT ERR]
Upper limit value malfunction of front door satellite sensor LH
B0093–25
[SELF-DIAG ERR]
Diagnosis malfunction of front door satellite sensor LH
B0093–28
[OFFSET ERR]
Offset malfunction of front door satellite sensor LH
B0093–81
[COMM ERR]
Communication malfunction of front door satellite sensor LH
B0093–93
[RESET]
Reset malfunction of front door satellite sensor LH
B0093–86
[UNMATCH]
Front door satellite sensor LH is out of the specified specification
B0093–88
[OPEN]
Front door satellite sensor LH circuit is open
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст