Nissan Juke F15. Manual — part 617
EM-22
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
AIR CLEANER FILTER
AIR CLEANER FILTER
Exploded View
INFOID:0000000012197244
Removal and Installation
INFOID:0000000012197245
REMOVAL
1.
Mass air flow sensor
2.
Gasket
3.
Clamp
4.
Air duct (suction side)
5.
Clamp
6.
Air cleaner cover assembly
7.
Mounting rubber
8.
Air cleaner filter
9.
Air cleaner body assembly
10. Air duct inlet (lower)
11. Grommet
12. Air duct inlet (upper)
13. Grommet
14. Bracket
15. Mounting rubber
A.
To turbocharger
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
JPBIA4305GB
AIR CLEANER FILTER
EM-23
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
1. Remove air duct inlet (upper) (1).
2. Unhook the tabs (A) of both ends of the air cleaner cover.
3. Remove the air cleaner filter (1) and air cleaner body (2) from
the air cleaner case.
4. Remove the air cleaner filter from the air cleaner body.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Fixing clips shall be fixed after inserting air cleaner body protrusion to air cleaner case notch hole.
• Make sure that whether air cleaner body has been firmly installed by shaking it.
Inspection (Viscous Paper Type)
INFOID:0000000012197246
INSPECTION AFTER REMOVAL
Examine with eyes that there is no stain, clogging, or damage on air cleaner element.
• Remove dusts (such as dead leafs) on air cleaner element surface and inside cleaner case.
• If clogging or damage is observed, replace the air cleaner element.
CAUTION:
Never clean the viscous paper type air cleaner element by blowing as there is a risk of deterioration of
its performance
MAINTENANCE INTERVAL
MA-7, "Introduction of Periodic Maintenance"
JPBIA4352ZZ
JPBIA4353ZZ
EM-24
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
SPARK PLUG
SPARK PLUG
Exploded View
INFOID:0000000012197247
Removal and Installation
INFOID:0000000012197248
REMOVAL
1. Remove engine cover. Refer to
2. Remove air inlet tube assembly. Refer to
.
3. Remove ignition coil.
1.
Rocker cover protector
2.
O-ring
3.
PCV valve
4.
PCV hose
5.
Clamp
6.
Rocker cover gasket
7.
Rocker cover
8.
Clamp
9.
PCV hose
10. Oil filler cap
11. Spark plug
12. Ignition coil
A.
To intake manifold
B.
Comply with the assembly procedure
when tightening. Refer to
C.
To air duct
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
JPBIA4303GB
SPARK PLUG
EM-25
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
4. Remove spark plug with a spark plug wrench (commercial ser-
vice tool).
CAUTION:
Never drop or shock spark plug.
INSTALLATION
Install in the reverse order of removal.
Inspection
INFOID:0000000012197249
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.
CAUTION:
• Never drop or shock spark plug.
• Never use a wire brush for cleaning.
• If plug tip is covered with carbon, spark plug cleaner may be
used.
• Spark plug gap adjustment is not required between replace-
ment intervals.
• Measure spark plug gap. when it exceeds the limit, replace
spark plug even if it is with in the specified replacement mile-
age. Refer to
.
a
: 14 mm (0.55 in)
JPBIA0030ZZ
Spark plug (Standard type)
: Refer to
.
Cleaner air pressure : Less than 588 kPa (6 kg/cm
2
,
85 psi)
Cleaning time
: Less than 20 seconds
SMA773C
JPBIA0031ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст