Nissan Juke F15. Manual — part 40
AV-146
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
U1232 STEERING ANGLE SENSOR
U1232 STEERING ANGLE SENSOR
DTC Logic
INFOID:0000000012202550
Diagnosis Procedure
INFOID:0000000012202551
1.
REGISTER THE NEUTRAL POSITION OF THE STEERING ANGLE SENSOR
1. Turn the ignition switch ON.
2. Perform registration of the neutral position of the steering angle sensor. Refer to
3. Check “Self Diagnostic Result” of “AVM” with CONSULT.
Is “U1232” detected as the current malfunction?
YES
>> GO TO 2.
NO
>> INSPECTION END
2.
CHECK STEERING ANGLE SENSOR
Check steering angle sensor. Refer to
Is the inspection result normal?
YES
>> Replace the around view monitor control unit. Refer to
AV-190, "Removal and Installation"
NO
>> Repair or replace malfunctioning parts.
DTC
Trouble diagnosis name
DTC detecting condition
Possible causes
U1232
ST ANGLE SEN CALIB
The neutral position registration of the steering angle sen-
sor can not finish.
• Steering angle sensor
• Around view monitor control unit
AV
U1244 GPS ANTENNA
AV-147
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
U1244 GPS ANTENNA
DTC Logic
INFOID:0000000012202552
Diagnosis Procedure
INFOID:0000000012202553
1.
GPS ANTENNA CHECK
Visually check GPS antenna and antenna feeder.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair malfunctioning parts.
2.
CHECK NAVI CONTROL UNIT VOLTAGE
1. Disconnect GPS antenna connector.
2. Turn ignition switch ON.
3. Check voltage between NAVI control unit and ground.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace NAVI control unit. Refer to
AV-182, "Removal and Installation"
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible cause
U1244
GPS ANTENNA CONN
(GPS antenna connection)
GPS antenna connection malfunction is detect-
ed.
• GPS antenna connector connection
• GPS antenna
(+)
(
−)
Standard
Voltage
(Approx.)
NAVI control unit
Terminal
54
Ground
—
5.0 V
AV-148
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
U1258 SATELLITE RADIO ANTENNA
U1258 SATELLITE RADIO ANTENNA
DTC Logic
INFOID:0000000012202554
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000012202555
Regarding Wiring Diagram information, refer to
1.
SATELLITE ANTENNA INSPECTION
Visually inspect the satellite antenna and antenna feeder. Refer to
.
Is inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace malfunctioning components.
2.
CHECK NAVI CONTROL UNIT VOLTAGE
1. Turn ignition switch ON.
2. Disconnect NAVI control unit harness connector.
3. Check voltage between NAVI control unit connector and ground.
Is inspection result normal?
YES
>> Replace satellite radio antenna. Refer to
AV-187, "Removal and Installation"
NO
>> Replace NAVI control unit. Refer to
AV-182, "Removal and Installation"
CONSULT Display
DTC Detection Condition
Possible Cause
SXM ANTENNA CONN
[U1258]
Open or short to ground is detected in satellite
antenna connection.
• Satellite antenna disconnection.
• Open or short to ground in satellite antenna
signal circuit.
NAVI control unit
Ground
Voltage
Terminal
73
—
5.0 V
AV
U1263 USB
AV-149
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
U1263 USB
DTC Logic
INFOID:0000000012202556
Diagnosis Procedure
INFOID:0000000012202557
1.
CHECK USB HARNESS
Visually check USB harness.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Replace USB harness.
2.
CHECK USB CONNECTOR.
Visually check USB connector.
Is the inspection result normal?
YES
>> Replace NAVI control unit. Refer to
AV-182, "Removal and Installation"
NO
>> Replace USB connector and AUX jack. Refer to
AV-196, "Removal and Installation"
.
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible cause
U1263
USB OVERCURRENT
(USB over current error)
Detection of overcurrent in USB connector.
• USB harness between the NAVI con-
trol unit
• USB connector
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст