Nissan Juke F15. Manual — part 714
EXL-76
< DTC/CIRCUIT DIAGNOSIS >
[XENON TYPE]
OPTICAL SENSOR
Is the inspection result normal?
YES
>> GO TO 8.
NO
>> Repair or replace harness.
8.
CHECK OPTICAL SENSOR SIGNAL CIRCUIT (SHORT)
Check continuity between optical sensor harness connector and ground.
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-94, "Removal and Installation"
NO
>> Repair or replace harness.
Optical sensor
BCM
Continuity
Connector
Terminal
Connector
Terminal
M84
2
M68
14
Existed
Optical sensor
—
Continuity
Connector
Terminal
M84
2
Ground
Not existed
HAZARD SWITCH
EXL-77
< DTC/CIRCUIT DIAGNOSIS >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
HAZARD SWITCH
Component Function Check
INFOID:0000000012201661
1.
CHECK HAZARD SWITCH SIGNAL
With CONSULT
1. Turn ignition switch ON.
2. Select “FLASHER” of “BCM” using CONSULT.
3. Select “HAZARD SW” in “Data Monitor” mode.
4. With operating the hazard switch, check the monitor status.
Is the inspection result normal?
YES
>> Hazard switch circuit is normal.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000012201662
1.
CHECK HAZARD SWITCH SIGNAL
1. Turn ignition switch OFF.
2. Disconnect hazard switch connector.
3. Check voltage between hazard switch connector and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> GO TO 2.
2.
CHECK HAZARD SWITCH SIGNAL CIRCUIT (OPEN)
1. Disconnect BCM connector.
2. Check continuity between hazard switch harness connector and BCM harness connector.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace harness.
3.
CHECK HAZARD SWITCH SIGNAL CIRCUIT (SHORT)
Check continuity between hazard switch harness connector and ground.
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-94, "Removal and Installation"
Monitor item
Condition
Monitor status
HAZARD SW
Hazard switch
ON
On
OFF
Off
+
-
Voltage
(Approx.)
Hazard switch
Connector
Terminal
M45
2
Ground
12 V
Hazard switch
BCM
Continuity
Connector
Terminal
Connector
Terminal
M45
2
M68
29
Existed
Hazard switch
—
Continuity
Connector
Terminal
M45
2
Ground
Not existed
EXL-78
< DTC/CIRCUIT DIAGNOSIS >
[XENON TYPE]
HAZARD SWITCH
NO
>> Repair or replace harness.
4.
CHECK HAZARD SWITCH GROUND CIRCUIT
Check continuity between hazard switch harness connector and ground.
Is the inspection result normal?
YES
>> Replace hazard switch. Refer to
EXL-107, "Removal and Installation"
NO
>> Repair or replace harness.
Hazard switch
—
Continuity
Connector
Terminal
M45
1
Ground
Existed
EXTERIOR LIGHTING SYSTEM SYMPTOMS
EXL-79
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
SYMPTOM DIAGNOSIS
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000012201663
EXCEPT FOR NISMO MODELS
Without Daytime Running Light System
NOTE:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any
DTC is detected.
Symptom
Possible cause
Inspection item
Headlamp (HI) is not turned
ON
One side
• Fuse
• Headlamp (HI) power supply/
ground circuit
• Headlamp (HI) bulb
• Headlamp assembly
- Harness
• IPDM E/R
Headlamp (HI) circuit
Refer to
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON”
Refer to
.
High beam indicator lamp is not turned ON
[Headlamp (HI) is turned ON]
Combination meter
• Combination meter
Data monitor “HI-BEAM IND”
• BCM (HEAD LAMP)
Active test “HEAD LAMP”
Headlamp (LO) is not
turned ON
One side
• Fuse
• Headlamp (LO) power supply/
ground circuit
• Headlamp (LO) bulb
(Xenon bulb)
• Headlamp assembly
- HID control unit
- Xenon bulb socket
- Harness
• IPDM E/R
Headlamp (LO) circuit
Refer to
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON”
Refer to
.
Each lamp is not turned ON/OFF with lighting switch
AUTO
• Combination switch input/output
signal circuit
• Combination switch
• BCM
Combination switch
Refer to
• Optical sensor power supply/
ground/signal circuit
• Optical sensor
• BCM
Optical sensor
Refer to
Parking lamp is not turned ON
• Parking lamp power supply/
ground circuit
• Front combination lamp
- LED (Parking lamp)
- Harness
• IPDM E/R
Parking lamp circuit
Refer to
Front side marker lamp is not turned ON
• Front side marker lamp power
supply/ground circuit
• Front side marker lamp bulb
• Front side marker lamp bulb sock-
et
Front side marker lamp circuit
Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст