Nissan Juke F15. Manual — part 985
MA-32
< PERIODIC MAINTENANCE >
ENGINE MAINTENANCE (MR EXCEPT FOR NISMO RS MODELS)
3. Remove the air cleaner filter (1) and air cleaner body (2) from
the air cleaner case.
4. Remove the air cleaner filter from the air cleaner body.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Fixing clips shall be fixed after inserting air cleaner body protrusion to air cleaner case notch hole.
• Make sure that whether air cleaner body has been firmly installed by shaking it.
ENGINE OIL
ENGINE OIL : Draining
INFOID:0000000012200207
WARNING:
• Be careful not to get burned, as engine oil may be hot.
• Prolonged and repeated contact with used engine oil may cause skin cancer. Try to avoid direct skin
contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as
soon as possible.
1. Warm up the engine, and check for engine oil leakage from engine components. Refer to
2. Stop the engine and wait for 10 minutes.
3. Loosen oil filler cap.
4. Remove drain plug and then drain engine oil.
ENGINE OIL : Refilling
INFOID:0000000012200208
1. Install drain plug with new drain plug washer. Refer to
CAUTION:
Be sure to clean drain plug and install with new drain plug washer.
2. Refill with new engine oil.
Engine oil specification and viscosity: Refer to
MA-11, "Fluids and Lubricants"
.
CAUTION:
• The refill capacity depends on the engine oil temperature and drain time. Use these specifica-
tions for reference only.
• Always use oil level gauge to determine the proper amount of engine oil in the engine.
3. Warm up engine and check area around drain plug and oil filter for engine oil leakage.
4. Stop engine and wait for 10 minutes.
5. Check the engine oil level. Refer to
.
OIL FILTER
OIL FILTER : Removal and Installation
INFOID:0000000012200209
REMOVAL
JPBIA4353ZZ
Tightening torque
: Refer to
.
Engine oil capacity
: Refer to
ENGINE MAINTENANCE (MR EXCEPT FOR NISMO RS MODELS)
MA-33
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
1. Remove oil filter using an oil filter wrench [SST: KV10115801]
(A).
CAUTION:
• Never get burned when engine or engine oil is heated.
• Use a shop cloth to absorb engine oil leakage when
removing.
• Never spill engine oil on the drive belt.
• Completely wipe away any engine oil spilled on the
engine and vehicle.
INSTALLATION
1. Eliminate foreign materials on the oil filter mounting surface.
2. Apply engine oil to the full circumference of the oil seal on a new
oil filter.
3. Screw in oil filter by hand until it contacts mounting surface on
the engine, and then screw in another 2/3 of a turn (A).
NOTE:
Tightening torque is 17.7 N·m (1.8 kg-m).
OIL FILTER : Inspection
INFOID:0000000012200210
INSPECTION AFTER INSTALLATION
1. Use the oil level gauge and check that the oil level is within the standard. Refer to
2. Start the engine. Check for fuel leakage.
3. Stop the engine. After stopping it, leave it for 10 minutes or more.
4. Check the engine oil level again. Fill with engine oil to adjust oil level if necessary. Refer to
SPARK PLUG
SPARK PLUG : Removal and Installation
INFOID:0000000012200211
REMOVAL
1. Remove the engine cover. Refer to
.
2. Remove air inlet tube 2. Refer to
EM-194, "Removal and Installation"
3. Remove the ignition coil. Refer to
: Vehicle front
JPBIA4450ZZ
SMA010
JPBIA0077ZZ
MA-34
< PERIODIC MAINTENANCE >
ENGINE MAINTENANCE (MR EXCEPT FOR NISMO RS MODELS)
4. Remove spark plug with a spark plug wrench (commercial ser-
vice tool).
CAUTION:
Never drop or shock spark plug.
INSTALLATION
Install in the reverse order of removal.
SPARK PLUG : Inspection
INFOID:0000000012200212
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.
CAUTION:
• Never drop or shock spark plug.
• Never use a wire brush for cleaning.
• If plug tip is covered with carbon, spark plug cleaner may be
used.
• Spark plug gap adjustment is not required between replace-
ment intervals.
• Measure spark plug gap. when it exceeds the limit, replace
spark plug even if it is with in the specified replacement mile-
age. Refer to
.
EVAP VAPOR LINES
EVAP VAPOR LINES : Inspection
INFOID:0000000012200213
1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections,
chafing and deterioration. Refer to
.
2. Inspect fuel tank filler cap vacuum relief valve for clogging, sticking, etc.
Refer to
EC-1017, "Component Inspection"
.
a
: 14 mm (0.55 in)
JPBIA0030ZZ
Spark plug (Standard type)
: Refer to
.
Cleaner air pressure : Less than 588 kPa (6 kg/cm
2
,
85 psi)
Cleaning time
: Less than 20 seconds
SMA773C
JPBIA0031ZZ
CHASSIS MAINTENANCE
MA-35
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
CHASSIS MAINTENANCE
EXHAUST SYSTEM
EXHAUST SYSTEM : Inspection
INFOID:0000000012200214
Check exhaust pipes, muffler, and mounting for improper attach-
ment, leakage, cracks, damage or deterioration.
• If anything is found, repair or replace damaged parts.
CVT FLUID (RE0F10B)
CVT FLUID (RE0F10B) : Inspection
INFOID:0000000012200215
CHECKING CVT FLUID
The fluid level should be checked with the fluid warmed up to 50 to 80
°C (122 to 176°F). The fluid level check
procedure is as follows:
1. Check for fluid leakage.
2. With the engine warmed up, drive the vehicle in an urban area.
When ambient temperature is 20
°C (68°F), it takes about 10
minutes for the CVT fluid to warm up to 50 to 80
°C (122 to
176
°F).
3. Park the vehicle on a level surface.
4. Apply parking brake firmly.
5. With engine at idle, while depressing brake pedal, move shift
selector throughout the entire shift range.
6. Pull out the CVT fluid level gauge from the CVT fluid charging
pipe after pressing the tab on the CVT fluid level gauge to
release the lock.
7. Wipe fluid off the CVT fluid level gauge. Insert the CVT fluid
level gauge rotating 180
° from the originally installed position,
then securely push the CVT fluid level gauge until it meets the
top end of the CVT fluid charging pipe.
CAUTION:
When wiping away the CVT fluid level gauge, always use
lint-free paper, not a cloth rag.
SMA211A
SMA146B
SCIA1933E
SCIA1931E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст