Nissan Juke F15. Manual — part 986
MA-36
< PERIODIC MAINTENANCE >
CHASSIS MAINTENANCE
8. Place the selector lever in “P” or “N” and check that the fluid
level is within the specified range.
CAUTION:
When reinstalling CVT fluid level gauge, insert it into the
CVT fluid charging pipe and rotate it to the original installa-
tion position until securely locked.
CVT FLUID CONDITION
Check CVT fluid condition.
• If CVT fluid is very dark or smells burned, check operation of CVT.
Flush cooling system after repair of CVT.
• If CVT fluid contains frictional material (clutches, brakes, etc.),
replace radiator and flush cooler line using cleaning solvent and
compressed air after repair of CVT. Refer to
CVT FLUID (RE0F10D)
CVT FLUID (RE0F10D) : Inspection
INFOID:0000000012200216
FLUID LEAKAGE
• Check transaxle surrounding area (oil seal and plug etc.)for fluid
leakage.
• If anything is found, repair or replace damaged parts and adjust
CVT fluid level. Refer to
GEAR OIL (RS6F94R)
GEAR OIL (RS6F94R) : Inspection
INFOID:0000000012200217
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
SCIA1932E
Fluid status
Conceivable cause
Required operation
Varnished (viscous
varnish state)
CVT fluid become
degraded due to
high temperatures.
Replace the CVT fluid and check the
CVT main unit and the vehicle for
malfunctions (wire harnesses, cool-
er pipes, etc.)
Milky white or
cloudy
Water in the fluid
Replace the CVT fluid and check for
places where water is getting in.
Large amount of
metal powder mixed
in
Unusual wear of
sliding parts within
CVT
Replace the CVT fluid and check for
improper operation of the CVT.
ATA0022D
SMA146B
CHASSIS MAINTENANCE
MA-37
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
1. Remove filler plug (1) and gasket from transaxle case.
2. Check the oil level from filler plug mounting hole as shown in the
figure.
CAUTION:
Never start engine while checking oil level.
3. Set a gasket on filler plug and then install it to transaxle case.
CAUTION:
Never reuse gasket.
4. Tighten filler plug to the specified torque. Refer to
GEAR OIL (RS6F94R) : Draining
INFOID:0000000012200218
1. Start engine and let it run to warm up transaxle.
2. Stop engine. Remove drain plug (1) and gasket, using a socket
[Commercial service tool] and then drain gear oil.
3. Set a gasket on drain plug and install it to clutch housing, using
a socket [Commercial service tool].
CAUTION:
Never reuse gasket.
4. Tighten drain plug to the specified torque. Refer to
GEAR OIL (RS6F94R) : Refilling
INFOID:0000000012200219
1. Remove filler plug (1) and gasket from transaxle case.
2. Fill with new gear oil until oil level reaches the specified limit at
filler plug mounting hole as shown in the figure.
3. After refilling gear oil, check the oil level. Refer to
"GEAR OIL (RS6F94R) : Inspection"
4. Set a gasket on filler plug and then install it to transaxle case.
CAUTION:
Never reuse gasket.
5. Tighten filler plug to the specified torque. Refer to
GEAR OIL (RS6F52H)
GEAR OIL (RS6F52H) : Inspection
INFOID:0000000012200220
OIL LEAKAGE
Make sure that gear oil is not leaking from transaxle or around it.
OIL LEVEL
SCIA7623E
SCIA7622E
Oil grade and
viscosity
: Refer to
MA-11, "Fluids and Lubricants"
.
Oil capacity
: Refer to
.
SCIA7623E
MA-38
< PERIODIC MAINTENANCE >
CHASSIS MAINTENANCE
1. Remove filler plug (1) and gasket from transaxle case.
2. Check the oil level from filler plug mounting hole as shown in the
figure.
CAUTION:
Never start engine while checking oil level.
3. Set a gasket on filler plug and then install it to transaxle case.
CAUTION:
Never reuse gasket.
4. Tighten filler plug to the specified torque. Refer to
GEAR OIL (RS6F52H) : Draining
INFOID:0000000012200221
1. Start engine and let it run to warm up transaxle.
2. Stop engine. Remove drain plug (1) and gasket, using a socket
[Commercial service tool] and then drain gear oil.
3. Set a gasket on drain plug and install it to clutch housing, using
a socket [Commercial service tool].
CAUTION:
Never reuse gasket.
4. Tighten drain plug to the specified torque. Refer to
GEAR OIL (RS6F52H) : Refilling
INFOID:0000000012200222
Refilling
1. Remove plug (1). Fill the transaxle with new oil and check the oil
level (L) using suitable gauge (A) as shown.
2. Install a new O-ring onto plug (1) and then install it to transaxle.
Tighten to the specified torque. Refer to
.
CAUTION:
Do not reuse O-ring.
CLUTCH FLUID
CLUTCH FLUID : Inspection
INFOID:0000000012200223
FLUID LEAKAGE
• Check clutch line for cracks, deterioration or other damage. Replace any damaged parts.
• Check for fluid leakage by fully depressing clutch pedal while engine is running.
CAUTION:
If leakage occurs around joints, reinstall the joints or, if necessary, replace damaged parts.
FLUID LEVEL
PCIB1968E
PCIB1834E
Oil grade and capacity
: Refer to
Oil level (L)
: 38.5 - 45.5 mm (1.516 - 1.791 in)
PCIB1968E
CHASSIS MAINTENANCE
MA-39
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
• Check that the fluid level in the reservoir tank is within the specified
range (MAX – MIN lines).
• Visually check for any clutch fluid leakage around the reservoir
tank.
• Check the clutch system for any leakage if the fluid level is
extremely low (lower than MIN).
TRANSFER OIL
TRANSFER OIL : Inspection
INFOID:0000000012200224
OIL LEAKAGE
Check transfer surrounding area (oil seal, drain plug, filler plug, and transfer case etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and gasket. Then check that oil is filled up
from mounting hole for the filler plug.
CAUTION:
Never start engine while checking oil level.
2. Before installing filler plug, set a new gasket. Install filler plug on
transfer and tighten to the specified torque. Refer to
CAUTION:
Never reuse gasket.
TRANSFER OIL : Draining
INFOID:0000000012200225
1. Run the vehicle to warm up the transfer unit sufficiently.
2. Stop the engine and remove the drain plug (1) and gasket to
drain the transfer oil.
3. Before installing drain plug, set a new gasket. Install drain plug
on the transfer and tighten to the specified torque. Refer to
.
CAUTION:
Never reuse gasket.
JPFIA0007ZZ
: Vehicle front
JSDIA2080ZZ
: Vehicle front
JSDIA2081ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст