Nissan Primera P12. Manual — part 593
LT-82
FRONT FOG LAMP
Aiming Adjustment
EKS009NJ
1.
Set the top edge of the fog lamp lens as shown in the figure.
2.
Turn front fog lamps ON.
3.
Adjust front fog lamps as shown in the figure.
●
When
performing
adjustment,
if
necessary,
cover
the
headlamps and opposite fog lamp.
Bulb Replacement
EKS009NK
1.
Remove fender protector.
2.
Turn bulb counterclockwise then remove it.
CAUTION:
●
Do not touch the glass of bulb directly by hand. Keep
grease and other oily matters away from it. Do not touch
bulb by hand while it is lit or right after being turned off.
Burning may result.
●
Do not leave bulb out of headlamp reflector for a long time
because dust, moisture smoke, etc. may affect the perfor-
mance of headlamp. When replacing bulb, be sure to
replace it with new one.
●
When bulb is installed, be sure to lock plastic cap to ensure watertightness.
Removal and Installation
EKS009NL
REMOVAL
1.
Remove fender protector. Refer to EI section in P12 ESM (SM2E00-1P12E0E).
2.
Disconnect fog lamp connector.
MKIB0151E
MKIB0152E
MKIB0153E
Front fog lamp
: 12V - 55W (H11)
MKIB0124E
FRONT FOG LAMP
LT-83
C
D
E
F
G
H
I
J
L
M
A
B
LT
3.
Remove fog lamp mounting bolt.
4.
Pull out fog lamp from vehicle and disconnect connector.
INSTALLATION
●
Install fog lamp in the reverse order of removal, observing the tightening torque shown below.
Fog lamp mounting bolt
MKIB0125E
: 3.3 - 7.7 N·m (0.33 - 0.79 kg-m, 29 - 69 in-lb)
LT-84
REAR FOG LAMP
REAR FOG LAMP
PFP:26550
Wiring Diagram — R/FOG — /Without Front Fog Lamp
EKS009NM
MKWA1113E
REAR FOG LAMP
LT-85
C
D
E
F
G
H
I
J
L
M
A
B
LT
MKWA1114E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст