Nissan Juke (2012 year). Service Repair Manual — part 5

AV

TWEETER

AV-61

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

TWEETER

Removal and Installation

INFOID:0000000007577930

REMOVAL

1.

Remove front pillar garnish. Refer to

INT-17, "Exploded View"

.

2.

Remove tweeter clip, then disconnect tweeter connector and remove tweeter.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV-62

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

REAR DOOR SPEAKER

REAR DOOR SPEAKER

Removal and Installation

INFOID:0000000007577931

REMOVAL

1.

Remove rear door finisher. Refer to

INT-15, "Exploded View"

.

2.

Remove rear door speaker screws, then disconnect rear door speaker connector and remove rear door
speaker.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV

SATELLITE RADIO TUNER

AV-63

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

SATELLITE RADIO TUNER

Removal and Installation

INFOID:0000000007577932

REMOVAL

1.

Remove luggage side lower finisher LH. Refer to

INT-32, "Exploded View"

.

2.

Disconnect satellite radio tuner connectors.

3.

Remove screws to remove satellite radio tuner and brackets as a single unit.

4.

Remove brackets screws to remove satellite radio tuner.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV-64

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

ANTENNA BASE

ANTENNA BASE

Exploded View

INFOID:0000000007577933

Removal and Installation

INFOID:0000000007577934

REMOVAL

1.

Remove headlining. Refer to

INT-26, "NORMAL ROOF : Exploded View"

(normal roof) or

INT-29, "SUN-

ROOF : Exploded View"

(sunroof).

2.

Disconnect antenna feeder connector.

3.

Remove nut to remove antenna base.

INSTALLATION

Install in the reverse order of removal.

CAUTION:

If the antenna base mounting nut is tightened looser than the specified torque, then this will lower the
sensitivity of the antenna. On the other hand, if the nut is tightened tighter than the specified torque,
then this will deform the roof panel.

JSNIA3161GB

1.

Antenna rod

2.

Antenna base

:

N·m (kg-m, in-fb)

Revision: 2011 October

2012 JUKE

AV

TEL ADAPTER UNIT

AV-65

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

TEL ADAPTER UNIT

Removal and Installation

INFOID:0000000007577935

REMOVAL

1.

Remove glove box assembly. Refer to

IP-11, "Exploded View"

.

2.

Remove TEL adapter unit screws.

3.

Disconnect TEL adapter unit connectors to remove TEL adapter unit and bracket as a single unit.

4.

Remove bracket screws to remove TEL adapter unit.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV-66

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

MICROPHONE

MICROPHONE

Removal and Installation

INFOID:0000000007577936

REMOVAL

1.

Remove headlining. Refer to

INT-26, "NORMAL ROOF : Exploded View"

(normal roof) or

INT-29, "SUN-

ROOF : Exploded View"

(sunroof).

2.

Remove microphone connector and pawl to remove microphone.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV

IPOD ADAPTER

AV-67

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

IPOD ADAPTER

Removal and Installation

INFOID:0000000007577937

REMOVAL

1.

Remove glove box assembly. Refer to

IP-11, "Exploded View"

.

2.

Remove iPod adapter connector and screws.

3.

Remove iPod adapter and brackets from the vehicle as a single unit.

4.

Remove brackets screws to remove iPod adapter.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV-68

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

IPOD CONNECTOR

IPOD CONNECTOR

Removal and Installation

INFOID:0000000007577938

REMOVAL

1.

Remove glove box assembly. Refer to

IP-11, "Exploded View"

.

2.

Push the pawl from the back of glove box assembly to remove iPod connector.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV

STEERING SWITCH

AV-69

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

STEERING SWITCH

Exploded View

INFOID:0000000007577939

Refer to

SR-10, "Exploded View"

.

Removal and Installation

INFOID:0000000007577940

REMOVAL

Refer to

SR-10, "Removal and Installation"

.

INSTALLATION

Install in the reverse order of removal.

Revision: 2011 October

2012 JUKE

AV-70

< REMOVAL AND INSTALLATION >

[AUDIO WITHOUT NAVIGATION]

ANTENNA FEEDER

ANTENNA FEEDER

Feeder Layout

INFOID:0000000007577941

JSNIA3612GB

Revision: 2011 October

2012 JUKE

AV

PRECAUTIONS

AV-71

< PRECAUTION >

[AUDIO WITH NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

PRECAUTION

PRECAUTIONS

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"

INFOID:0000000007577942

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” of this
Service Manual.

WARNING:

Always observe the following items for preventing accidental activation.
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in

the event of a collision that would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.

• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal

injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see “SRS AIR BAG”.

• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-

vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation.
• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the

ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with
a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.

• When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the

battery, and wait at least 3 minutes before performing any service.

Precaution for Trouble Diagnosis

INFOID:0000000007577943

AV COMMUNICATION SYSTEM

• Do not apply voltage of 7.0 V or higher to the measurement terminals.
• Use the tester with its open terminal voltage being 7.0 V or less.
• Be sure to turn ignition switch OFF and disconnect the battery cable from the negative terminal before

checking the circuit.

Precaution for Harness Repair

INFOID:0000000007577944

AV COMMUNICATION SYSTEM

• Solder the repaired parts, and wrap with tape. [Frays of twisted line

must be within 110 mm (4.33 in).]

PKIA0306E

Revision: 2011 October

2012 JUKE

AV-72

< PRECAUTION >

[AUDIO WITH NAVIGATION]

PRECAUTIONS

• Do not perform bypass wire connections for the repair parts. (The

spliced wire will become separated and the characteristics of
twisted line will be lost.)

PKIA0307E

Revision: 2011 October

2012 JUKE

AV

PREPARATION

AV-73

< PREPARATION >

[AUDIO WITH NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

PREPARATION

PREPARATION

Commercial Service Tools

INFOID:0000000007577945

Tool name

Description

Power tool

Loosening screws

PBIC0191E

Revision: 2011 October

2012 JUKE

AV-74

< SYSTEM DESCRIPTION >

[AUDIO WITH NAVIGATION]

COMPONENT PARTS

SYSTEM DESCRIPTION

COMPONENT PARTS

Component Parts Location

INFOID:0000000007577946

1.

Front door speaker LH

2.

Rear door speaker LH

3.

Woofer

4.

Rear view camera

5.

Rear door speaker RH

6.

Antenna rod

7.

Antenna base (antenna amp. and
satellite radio antenna)

8.

Front door speaker RH

9.

Microphone

10.

GPS antenna

11. Tweeter LH

12. Steering switch

13.

USB connector and AUX jack

14. TEL antenna

15. TEL adapter unit

16.

Tweeter RH

17. NAVI control unit

A.

Luggage side LH

B.

Back of back door finisher

C.

Back of headlining

D.

Back of instrument panel

E.

Glove box assembly removed condi-
tion

F.

Front pillar finisher removed condi-
tion

: Vehicle front

JSNIA3613ZZ

Revision: 2011 October

2012 JUKE

AV

COMPONENT PARTS

AV-75

< SYSTEM DESCRIPTION >

[AUDIO WITH NAVIGATION]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

Component Description

INFOID:0000000007577947

Part name

Description

NAVI control unit

• Operational switch of navigation system and audio system are integrated.
• Includes the audio, hands-free phone, navigation, satellite radio, rear view

monitor, USB connection and AUX connection functions.

• Map data can be loaded from the SD-card inserted in the built-in SD-card

slot.

• Sound signals are output to each speaker and woofer.
• It inputs the illumination signals that are required for the display dimming con-

trol.

• It inputs the signals for driving status recognition (vehicle speed, reverse and

parking brake).

• Touch panel function can be operated for each system by touching a display

directly.

• It supplies power to rear view camera.
• Camera image signal is input from rear view camera.

Map SD-card

A collection of Map data.

Front door speaker

• Outputs sound signal from NAVI control unit.
• Outputs mid and low range sounds.

Tweeter

• Outputs sound signal from NAVI control unit.
• Outputs high range sounds.

Rear door speaker

• Outputs sound signal from NAVI control unit.
• Outputs high, mid and low range sounds.

Woofer

• Woofer amp. ON signal is input from NAVI control unit.
• Outputs sound signal from NAVI control unit.
• Outputs low range sounds.

Steering switch

• Operations for audio and hands-free phone are possible.
• Steering switch signal (operation signal) is output to NAVI control unit.

TEL adapter unit

• Inputs the TEL voice signal from TEL antenna and outputs it to the NAVI con-

trol unit.

• It is connected with the NAVI control unit via AV communication and con-

trolled with the NAVI control unit.

TEL antenna

• Receives the TEL voice signal and outputs it to the TEL adapter unit.
• TEL antenna is unified with a TEL adapter unit.

Microphone

• Used for hands-free phone operation.
• Microphone signal is transmitted to TEL adapter unit.
• Power (microphone VCC) is supplied from TEL adapter unit.

GPS antenna

GPS signal is received and transmitted to NAVI control unit.

Antenna base

A radio antenna base integrated with radio antenna amp. and satellite radio an-
tenna is adopted.

ANTENNA AMP.

• Radio signal received by rod antenna is amplified and transmitted to NAVI

control unit.

• Power (antenna amp. ON signal) is supplied from NAVI control unit.

SATELLITE RADIO ANTENNA

• Receives satellite radio waves and outputs it to NAVI control unit.

Rear view camera

• Camera power supply is input from NAVI control unit.
• The image of vehicle rear view is transmitted to NAVI control unit.

USB connector and AUX jack

• Sound signal of auxiliary input is transmitted to NAVI control unit.
• Sound signal of USB input is transmitted to NAVI control unit.

Revision: 2011 October

2012 JUKE

AV-76

< SYSTEM DESCRIPTION >

[AUDIO WITH NAVIGATION]

SYSTEM

SYSTEM

System Diagram

INFOID:0000000007577948

NOTE:
An antenna base integrated with radio antenna amp. and satellite
radio antenna is adopted.

System Description

INFOID:0000000007577949

Refer to Owner’s Manual for navigation and audio system operating instructions.
Audio function and display are built into NAVI control unit.
This navigation has the following functions.
• Map data on SD-card.
• Full support for playback of music from iPod

®

and USB device.

• High resolution color 5 inch display with touch panel function.
• FM/AM twin digital tuner.
• USB mass storage connection.
• Satellite radio.
• Hands-free phone system.
iPod

®

is a trademark of Apple inc., registered in the U.S. and other countries.

NAVIGATION SYSTEM FUNCTION

Description

• The navigation system can be operated by control panel of the NAVI control unit and display (touch panel) of

the NAVI control unit.

JSNIA3621GB

JSNIA1062GB

Revision: 2011 October

2012 JUKE