Kia Carnival (2007 year). Manual — part 12

6. Install the camshaft bearing caps.

Tightening torque
Bearing cap bolt(A: 6

×38) - 10.8~12.7Nm(1.1~1.3kgf.m, 8.0~9.4lb-ft)

Bearing cap bolt(B: 8

×38) - 20.6~22.5Nm(2.1~2.6kgf.m, 15.2~18.8lb-ft)

When installing the bearing caps, check the marks on them as shown below and install them in its proper
position.

A(LH/RH HEAD): L(LH), R(RH)
B(Intake/Exhaust): I(Intake), E(Exhaust)
C(Cap no.): 1,2,3

When installing the bearing caps, turn the crankshaft to place a piston in the middle of the block because
linterference between valves and pistons can occur.

7. Using the SST(09214-21000), install the camshaft oil seal.

a. Befor installing, apply engine oil.

b. The camshaft cap surface should adhere to the cylinder head assembly.

c. Do not press an eccentric load.

8. Install the CKP sensor connector bracket(A).

9. Install the bank 1 timing belt rear cover(A).

10. Install the bank 2 timing belt rear cover(A).

The length of the bolt(B) is longer than that of the bolt(C).

11. Install the timing belt.(Refer to 'Timing system').

12. Check and adjust the valve clearance.

13. Install the cylinder head cover.

(1) Remove oil, dust or sealant on the upper surface of the cylinder before assembling cylinder head cover.

(2) Assemble the cylinder head cover in five minites after applying liquid gasket(LOCTITE 5900) on the camshaft

cap and packing part.

(3) Tighten the cylinder head cover bolts as following order(A).

Tightening torque
7.8~9.8Nm(0.8~1.0kgf.m, 5.8~7.2lb-ft)

a. Do not start engine for thirty minites after assembling the cylinder head cover.

b. Do not reuse the cylinder head cover gasket.

14. Install the water temp. control assembly.

15. Install the intake manifold assembly.

16. Install the exhaust mainfold assembly.

17. Install the power steering pump.(Refer to 'ST' group).

18. Install the drive belt(A).

19. Install the heater hose.

20. Connect the brake vaccume hose(A).

21. Install the PCV(Pulge Control Valve) hose(A).

22. Connect the engine wiring harness connectors.

(1) Connect the bank 1 CMP sensor connector(A).