Kia Carnival (2007 year). Manual — part 332

8. INSIDE/OUTSIDE DOOR HANDLE SWITCH

Power sliding door can be opened and closed manually/automatically from inside or outside vehicle.
Outside door handle switch (A)

Inside door handle switch (B)

OPERATION

POWER SLIDING DOOR OPEN/CLOSE

1. The right/left sliding door is opened and closed automatically if the main switch (A) is pressed on the overhead

console.

2. When the power ON/OFF button (PWR) (B) is ON, the power sliding door and power tailgate can be opened and

closed automatically by using trim switch.

3. When the sliding door window is open (more than 3 in/80 mm), the power sliding door will not power open fully but

will open to the 3/4 position and the chime will sound 3 times.

4. General rules for chime functions

a. Chime shall operate when a power operation cannot be performed as requested except handle pull : 1 Time

(Duration 0.5 second on)

b. Chime shall operate when an obstacle has been detected : 3 Time (0.5 sec on, 0.5 sec off)

c. Chime shall operate if PSD has not reached primary latch position after a power cinch cycle : 3 Time (0.5 sec

on, 0.5 sec off)

Do not leave the power sliding door at half-opened position. Close the window and then open the door fully.
Half-opened door is held and then released after 10 minutes. The chime sounds 3 times to indicate the door
is released. If the vehicle is stopped on a downward slope, it may move and cause an injury.

POWER SLIDING DOOR OPERATING CONDITION

1. The sliding door will not power open when vehicle is moving above 3 mph (5 km/h) or the gearshift lever is not in

P (Park) for automatic transaxle.

2. The power sliding door will not open with the transmitter or the main control button when all power sliding doors

are locked and closed.

3. The power sliding door will detect the resistance, then stop movement or move to the full open position to allow the

object to be cleared.

4. The left sliding door cannot be opened when the fuel filler lid is open.

5. If the automatic stop and reversal feature operates continuously more than twice during one opening or closing

operation, the power sliding door may stop at that position. At this time, close the doors manually and operate the
door automatically again.

6. The power sliding door can be opened by pulling the outside door handle while the door is unlocked and child

safety lock is engaged.

a. If the fuel filler lid is opened when the left sliding door is not closed completely, the door may be opened.

Close the left sliding door before refueling to prevent possible damage to the door or the fuel filler lid.

b. Sudden starting or accelerating the vehicle while the door is closing could cause it to open the door and

result in a serious injury or damage to cargo.

c. The PSDM will go to a sleep mode and power operation will be disabled if the sliding door is left open

longer than 6 hours. Manually close the sliding door to the latched position to reset the PSDM. Power
operation will be restored.

a. The door could suddenly close by itself and cause a serious injury especially when stopping on a down-hill

grade.

b. To prevent the battery from being discharged, do not leave the power sliding door and power tailgate at

open position for a long time.

a. Let the rear passengers get on or off the vehicle after the door is open fully. Sudden closing could cause a

serious injury.

b. To prevent power sliding door system, don't use excessive force to open/close the door during operation.

CHILD SAFETY LOCKS

To prevent children from opening the power sliding doors from the inside, the child safety locks (A) should be used
whenever children are in the vehicle.

Be careful, when the child safety lock is used in an accident, that the passengers are not held in vehicle.

POWER OPERATION

The PSD system shall not open the Sliding Door when the vehicle is moving.
The PSD system shall operate through the full range of Sliding Door travel.
The PSD system shall learn the position of each travel extreme: full open and full closed.

1. Vehicle condition

Moving

a. (IGN=OFF and Vehicle Speed > 5 km/h) or (IGN= ON and (Vehicle Speed > 5 km/h or PIN - not P/N))

Not moving

a. (IGN=OFF and Vehicle Speed < 5 km/h) or (IGN= ON and (Vehicle Speed < 5 km/h and TRANS - P/N))

2. DOOR TRAVEL - ZONES

The door travel is divided into four zones starting at the full closed and latched position.
Dimensions are at the rear edge of the door and are approximate.
Zone 1 - Latching - 0 to 10 mm (primary and secondary latch positions).
Zone 2 - Near latching position including curved track portion -10 to 300 mm.
Zone 3 - Straight track - 300 mm to hold open latch.
Zone 4 - Hold Open - door in hold open latch.

POWER SLIDING DOOR OPERATION

1. Vehicle condition

Stopping condition

a. When the ignition switch is in the OFF or ACC position, vehicle is stopped or moving below 5 km/h.

b. When the ignition switch is in the ON position, vehicle is stopped or moving below 5 km/h (the gearshift lever is

in N(Neutral) for manual transaxle, P(Park) for automatic transaxle).

Driving condition

a. When the ignition switch is in the OFF or ACC position, vehicle is moving above 5 km/h.

b. When the ignition switch is in the ON position, vehicle is moving above 5 km/h or the gearshift lever is not in

N(Neutral) for manual transaxle, P(Park) for automatic transaxle.