Kia Carnival (2009+). Manual — part 529

1. 14cm (Diameter) plastic rod is used for the test target.
2. The test result may differ by a different target object.
3. Detection range may be reduced by dirt accumulated on sensor, and extremely hot or cold weather.
4. The following object may not be detected.

- Sharp object or thin object like rope.
- Cotton, sponge, snow or other materials absorbing sonic wave.
- Smaller objects than 14cm (Diameter), 1m length.

2009 > G 2.7 DOHC >

REPLACEMENT

1. Remove the rear bumper ( Refer to the Body group - "Rear bumper")

2. Disconnect the sensor connector at the inside of the rear bumper (C), and then remove the sensor (B) from the

housing (A).

3. Installation is the reverse of removal procedure.

Body Electrical System

Rear Parking Assist System - Buzzer

Body Electrical System

2009 > G 2.7 DOHC >

INSPECTION

Test the buzzer by connecting battery voltage to terminal 1, and ground terminal 2.
The buzzer should make a sound. If the buzzer fails to make a sound, replace it.

REPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the crash pad lower panel (Refer to the Body group - crash pad).

3. Remove the buzzer (A) after loosening the bolt and disconnecting the connector from the left side of IPM.

4. Installation is the reverse of removal procedure.