Kia Carnival (2009+). Manual — part 265

Gasoline: 50 ~ 65 (5.0 ~ 6.5, 36 ~ 47)

9. Insert pry bar (C) between the transaxle case (B) and driveshaft joint (A), separate driveshaft from the transaxle.

• Use a pry bar being careful not to damage the transaxle and joint.
• Do not insert a pry bar too deep, as this may cause damage to the oil seal.
• Do not pry on the driveshaft by excessive force it may cause components inside the joint kit to dislodge

resulting in a torn boot or a damaged bearing.

10. Pull out the driveshaft from the transaxle case.

• Plug the hole of the transaxle case with the oil seal cap to prevent contamination.
• Replace the retainer ring whenever the driveshaft is removed from the transaxle case.

INSTALLATION

• Replace the circlip with new ones before the installation.
• Before the installation, apply the gear oil on the driveshaft splines (A) and contacting surface of differential

case oil seal (B).

1. Installation is reverse of the removal.

• The driveshaft lock nut should be replaced with new ones.
• After installation driveshaft lock nut, stake the lock nut using a chisel and hammer as shown in the

illustration below.

INSPECTION

1. Check the driveshaft boots for damage and deterioration.

2. Check the ball joints for wear and damage.

3. Check the splines for wear and damage.

4. Check the dynamic damper for cracks and wear.

INSPECTION

1. Check the drive shaft spline for wear or damage.

2. Check that there is no water or foreign material in the BJ.

3. Check the spider assembly for roller rotation, wear or corrosion.

4. Check the groove inside the UTJ case for wear or corrosion.

5. Check the dynamic damper for damage or cracks.

DISASSEMBLY

• Do not disassemble the BJ assembly.
• The Driveshaft joint uses special grease. Do not subtitute with another type of grease.
• The Boot band should be replaced with a new one.

1. Remove the TSJ boot band and pull the boot from TSJ outer race.

Be careful not to damage it.

2. Remove the circlip using a screwdriver.

3. Remove the driveshaft from TSJ outer race.

4. Remove the snap ring and disassemble the spider assembly from the shaft.

5. Clean the spider assembly.

6. Remove the BJ boot band and removal of the TSJ boot and the BJ boot.

If the boot is reused, wrap a tape around the driveshaft splines to protect the boot.