Kia Carnival (2009+). Manual — part 266

7. Remove both side of bands(B) of the dunamic damper(A).

8. Fix the drive shaft(A) with a vice(B) as illustrated.

9. Apply soapy water to the shaft to prevent being damaged between the shaftspline and the dynamic damper when

the dynamic damper is removed.

10. Separate dynamic damper(A) from the shaft(B) carefully.

DISASSEMBLY

• Do not disassemble the BJ assembly.
• Special grease must be applied to the drive shaft joint. Do not substitute with another type of grease.
• The boot band should be replaced with a new one.

1. Remove the clip (B) from drive shaft splines (A) of the transaxle side.

2. Remove both boot bands from the transaxle side UTJ case.

3. Pull out the boot from the transaxle side joint(UTJ).

4. When separating the joint and boot (A), remove the grease from the UTJ case (B).

• Be careful not to damage the boot.
• According to ullustration below, put alignment marks across spider roller assembly (A), UTJ case (B), and

shaft splines (C) to aid in reassembly.

5. Using a plier or flat-tipped (-) screwdriver, remove the snap ring (A).

6. Remove the spider assembly (B) from drive shaft (A) by using the Special Tool(09495-33000).

7. Clean the spider assembly.

8. Remove the boot (A), of the transaxle side joint(UTJ).

Wrap tape (B) around the driveshaft splines (C) to protect the boot (A).

9. Remove both side of bands (B, C) of the dynamic damper (A).

10. Fix the driveshaft (A) with a vice (B) as illustrated.

11. Apply soap powder on the shaft to prevent being damage between the shaft spline and the dynamic damper when

the dynamic damper is removal.

12. Separated dynamic damper (A) from the shaft (B) carefully.

13. Remove both bands on the side of wheel.