Kia Carnival (2009+). Manual — part 199

support them securely with floor jack.
Verify that the hoses and connectors are disconnected before removing the engine and transaxle assembly.

27. Remove the engine mounting bracket(A) and the ground(B).

28. Remove the transaxle insulator mounting bolt(A).

Remove the ECM(Electronic Controlled Mounting) nuts and the solenoid valve connector for A/T vehicles.

29. Supporting the engine and transaxle assembly with a jack, remove the assembly from the vehicle by loosening the

sub frame mounting bolts and lifting up the vehicle slowly.

When removing the engine and transaxle assembly, be careful not to damage any surrounding parts or body
components.

Front

Real

INSTALLATION

Installation is in the reverse order of removal.
Perform the following :

• Adjust the shift cable.
• Refill the engine with engine oil.
• Refill the transaxle with fluid.
• Refill the radiator with engine coolant.
• Bleed air from the cooling system with the heater valve open.
• Clean the battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent

corrosion.

• Inspect for fuel leakage.

After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for
approximately two seconds and fuel line pressurizes.
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.

Engine Mechanical System

Cylinder Block

Engine Mechanical System

2009 > G 2.7 DOHC >

COMPONENTS