Suzuki Grand Vitara JB627. Manual — part 408
10-ii Table of Contents
BCM Removal and Installation. . . . . . 10B-36
Outside Air Temperature Sensor Removal
and Installation . . . . . . . . . . . ..10B-36
Outside Air Temperature Sensor Inspection ...10B-36
DRL Function Setting Procedure . . . . . 10B-37
Special Tools and Equipment . . . . . . .10B-37
Special Tool . . . . . . . . . . . . . 10B-37
Immobilizer Control System. . . . . 10C-1
Precautions. . . . . . . . . . . . . . .10C-1
System . . . . . . . . . . . . . . . 10C-1
General Description . . . . . . . . . . ...10C-2
Immobilizer Control System Introduction . . ..10C-2
On-Board Diagnostic System Description
(Self-diagnosis Function) . . . . . . . . 10C-2
Schematic and Routing Diagram. . . . . ..10C-3
Immobilizer Control System Wiring Circuit
Diagram . . . . . . . . . . . . . . ..10C-3
Component Location . . . . . . . . . . .10C-4
Immobilizer Control System Components
Location . . . . . . . . . . . . . . ..10C-4
Diagnostic Information and Procedures. . ..10C-5
Immobilizer Control System Check . . . . ...10C-5
Diagnostic Trouble Code (DTC) Check. . . .10C-6
Diagnostic Trouble Code (DTC) Clearance . ..10C-6
Diagnostic Trouble Code (DTC) Table. . . ..10C-7
Scan Tool Data . . . . . . . . . . . . .10C-7
Immobilizer Indicator Light Does Not Come
ON with Ignition Switch ON and Engine Stop ..10C-8
Immobilizer Indicator Light Remains ON after
Engine Start . . . . . . . . . . . . . 10C-9
DTC P1614: Transponder Response Error. .10C-10
DTC P1615: Steering Lock Unit
Communication Error (for Vehicle with
Keyless Start System). . . . . . . . ...10C-11
DTC P1616: Unregistered Keyless Start
Control Module (for Vehicle with Keyless
Start System) . . . . . . . . . . . . 10C-13
DTC P1618: Keyless Start Control Module
CAN Communication Error (for Vehicle with
Keyless Start System). . . . . . . . ...10C-14
DTC P1621: Immobilizer Communication
Line Error . . . . . . . . . . . . . ..10C-16
DTC P1622: EEPROM Error. . . . . . ...10C-19
DTC P1623: Unregistered Transponder . . .10C-19
DTC P1625: Immobilizer Antenna Error. . ..10C-20
DTC P1636: Immobilizer Information
Registration Failure . . . . . . . . . ...10C-21
DTC P1638: Immobilizer Information
Mismatched. . . . . . . . . . . . ...10C-22
Inspection of Immobilizer Control Module
(ICM) and Its Circuit . . . . . . . . . ..10C-23
Repair Instructions . . . . . . . . . . ..10C-26
Immobilizer Control Module (ICM) Removal
and Installation . . . . . . . . . . . ..10C-26
Registration of the Ignition Key . . . . . ...10C-26
Procedure after ECM Replacement . . . . 10C-26
Special Tools and Equipment . . . . . . .10C-27
Special Tool . . . . . . . . . . . . . 10C-27
Keyless Start System . . . . . . . 10E-1
Precautions. . . . . . . . . . . . . . .10E-1
Precautions in Diagnosing Troubles . . . . .10E-1
General Description . . . . . . . . . . ...10E-2
Keyless Start System Description . . . . . .10E-2
Parts and Functions . . . . . . . . . . ..10E-3
Keyless Engine Start Function . . . . . . ..10E-4
Door Lock Function of Keyless Start System. 10E-5
Operation Area of Remote Controller. . . . 10E-6
Alarm Function . . . . . . . . . . . . ..10E-7
CAN Communication System Description. . .10E-7
Schematic and Routing Diagram . . . . . ..10E-8
Keyless Start System Electric Wiring Circuit
Diagram. . . . . . . . . . . . . . ...10E-8
Diagnostic Information and Procedures . . ..10E-9
Self-Diagnosis Function . . . . . . . . . 10E-9
Keyless Start System Diagnosis Introduction ...10E-9
Keyless Start System Check. . . . . . . .10E-9
Customer Questionnaire (Example). . . . 10E-10
Key Indicator Light Check . . . . . . . ...10E-11
DTC Check. . . . . . . . . . . . . ..10E-11
DTC Table. . . . . . . . . . . . . ...10E-12
DTC Clearance . . . . . . . . . . . ...10E-13
Keyless Start System Symptom Diagnosis . .10E-13
Keyless Start System Operation Inspection. 10E-14
Door Lock Operation Check (Keyless Start
System) . . . . . . . . . . . . . . .10E-15
Inspection of Keyless Start Control Module
and Its Circuits . . . . . . . . . . . ..10E-16
No DTC Detection After Performing DTC
Check . . . . . . . . . . . . . . . 10E-21
Key Indicator Light Circuit Check (Key
Indicator Light Doesn’t Light when Ignition
Knob Switch is Pushed) . . . . . . . . 10E-23
Keyless Start Control Module Power and
Ground Circuit Check. . . . . . . . . 10E-25
DTC No. 11: Communication Error with
Steering Lock Unit. . . . . . . . . . .10E-26
DTC No. 13 / No. 14: Release Signal Error
from Steering Lock Unit / Steering Lock Unit
Malfunction. . . . . . . . . . . . . 10E-27
DTC No. 21 / No. 22: Internal Error of Keyless
Start Control Module (EEPROM Reading
Error) / (EEPROM Writing Error). . . . ...10E-27
DTC No. 31: Lost Communication with BCM ..10E-28
DTC No. 33: Control Module Communication
Bus Off . . . . . . . . . . . . . . ..10E-30
DTC No. 51 / No. 52 / No. 53: Driver Side /
Passenger Side / Rear End Door Request
Switch Failure. . . . . . . . . . . . 10E-31
Repair Instructions . . . . . . . . . . ..10E-33
Antennas and Request Switches Removal
and Installation . . . . . . . . . . . ..10E-33
Table of Contents 10-iii
Steering Lock Unit Removal and Installation .. 10E-34
Steering Lock Unit Inspection . . . . . . . 10E-34
Front Door Lock Switch Inspection . . . . . 10E-34
Keyless Start Control Module Removal and
Installation. . . . . . . . . . . . . . 10E-35
Remote Controller Inspection. . . . . . ..10E-35
Replacement of Remote Controller Battery . 10E-36
Registration Procedure for Remote Controller
10-1 Precautions:
Control Systems
Precautions
Precautions
Precautions for Control Systems
S6JB0BA000001
Air Bag Warning
Refer to “Air Bag Warning in Section 00”.
Cruise Control System: 10A-1
Control Systems
Cruise Control System
Precautions
Precautions in Diagnosing Troubles
S6JB0BA100001
• Before confirming the diagnostic trouble code (DTC), do not disconnect connector from ECM, battery cable from
battery, ground wire harness, or main fuse. Such disconnection will erase DTC stored in ECM.
• DTC stored in ECM memory can be checked as well as cleared by using SUZUKI scan tool. Before using SUZUKI
scan tool, read its operator’s manual carefully to know how to use it and what functions are available.
• Be sure to read “Precaution for CAN Communication System in Section 00” before inspection.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст