Hummer H3. Manual — part 1446
62. Disengage the park brake.
ROOF IDENTIFICATION LAMP BULB REPLACEMENT
Removal Procedure
Fig. 152: Locating Fastener Covers
Courtesy of GENERAL MOTORS CORP.
1. Remove the 6 fastener covers (1) by inserting a flat-head screwdriver into the slot on the
passenger's side of each cover and gently lifting upward.
2. Using a T25® torx driver, loosen the 6 bolts under the fastener covers.
3. Rotate lightbar back so that lightbar is laying upside down on roof. Remove the bulb socket
from lamp assembly by rotating the bulb socket 1/4 turn counterclockwise.
4. Pull the bulb out of the socket.
5. Replace bulb.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Installation Procedure
1. Install the bulb socket into the lamp assembly by rotating the bulb socket 1/4 turn
clockwise.
2. Rotate lightbar to correct orientation and install the bolts using the T25 torx driver.
Tighten: 4.5 N.m (30 lb in).
3. Install the 6 fastener covers by aligning the tab to driver's side and gently pressing in place.
ROOF CLEARANCE LAMP BULB REPLACEMENT
Removal Procedure
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Fig. 153: Identifying Air Inlet Cover
Courtesy of GENERAL MOTORS CORP.
1. Remove the air inlet cover (1) by pulling up to release the clips.
2. Open the front doors.
3. Remove A-pillar trim by first peeling back the weatherstrip to expose the 2 screws.
4. Use a Phillips head screwdriver, to remove the screws.
5. Pull up on the lower end of the A-pillar trim to unsnap the clips (1).
6. Unhook the A-pillars from the front end of the luggage rack/siderail.
7. Remove bulb socket from the lamp assembly by rotating 1/4 turn counterclockwise.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
8. Pull the bulb out of the socket.
9. Replace the bulb.
Installation Procedure
1. Install the lamp socket into the lamp assembly by rotating the lamp socket 1/4 turn
clockwise.
Fig. 154: Removing/Installing A-pillar trim
Courtesy of GENERAL MOTORS CORP.
2. Install the A-pillar trim by hooking the rear edge under the tab (2) at the luggage
rack/siderail and pressing the clips (1) into place.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст