Hummer H3. Manual — part 1447
3. Install the 2 screws (4) behind weatherstrip.
Tighten: Tighten the screws to 2 N.m (18 lb in).
4. Reposition the weatherstrip (3).
PARKING AND TURN SIGNAL LAMP REPLACEMENT
Fig. 155: Replacing Parking and Turn Signal Lamp
Courtesy of GENERAL MOTORS CORP.
Parking and Turn Signal Lamp Replacement
NOTE:
Refer to Fastener Notice .
Callout
Component Name
Preliminary Procedure
1. Remove either the RH or LH front wheelhouse panel. Refer to Wheelhouse Panel
Replacement (Front) or Wheelhouse Panel Replacement (Rear) .
2. Remove the front grille. Refer to Grille Replacement .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
PARK/TURN SIGNAL LAMP BULB REPLACEMENT
3. Disconnect the electrical connector from the daytime running lamp (DRL) bulb
socket.
1
Park and Turn Signal Lamp Bolt (Qty: 3)
Tighten: 5 N.m (44 lb in)
Tip: Support the lamp assembly when removing the bolts.
NOTE:
Refer to Fastener Notice .
2
Park and Turn Signal Lamp Assembly
Tip:
1. Remove the bulb sockets from the park and turn signal lamp assembly.
2. Remove the park and turn signal lamp assembly by sliding forward.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Fig. 156: Replacing Park/Turn Signal Lamp Bulb
Courtesy of GENERAL MOTORS CORP.
Park/Turn Signal Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure:
Remove either the RH or LH front wheelhouse panel. Refer to Wheelhouse Panel
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
HIGH MOUNT STOP LAMP REPLACEMENT
Fig. 157: High Mounted Stop Lamp Replacement
Courtesy of GENERAL MOTORS CORP.
High Mount Stop Lamp Replacement
Replacement (Front) or Wheelhouse Panel Replacement (Rear) .
1
Park and Turn Signal Lamp Bulb
Tip:
1. Twist the lamp socket counterclockwise to remove from the lamp
assembly.
2. Remove the bulb from the lamp socket.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Remove the endgate upper interior trim panel.
Refer to Endgate Trim Panel Replacement .
NOTE:
Refer to Fastener Notice .
1
Connector, Electrical Harness (Qty: 1)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст