Hummer H3. Manual — part 262
Fig. 658: Installing Crankshaft Rear Oil Seal
Courtesy of GENERAL MOTORS CORP.
1. Use the plastic installation sleeve supplied with the new seal when installing a new seal.
Use J 44215 to install the crankshaft rear oil seal. See Special Tools.
2. Remove J 44215 . See Special Tools.
ENGINE FLYWHEEL INSTALLATION (AUTOMATIC TRANSMISSION)
Tools Required
J 45059 Angle Meter. See Special Tools.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Fig. 659: Installing Flywheel - Automatic Transmission
Courtesy of GENERAL MOTORS CORP.
1. Install the flywheel.
2. Install new flywheel bolts.
Tighten:
1. Tighten the new flywheel bolts to 40 N.m (30 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
2. Use J 45059 to tighten the flywheel bolts an additional 45 degrees. See Special Tools.
ENGINE FLYWHEEL INSTALLATION (MANUAL TRANSMISSION)
Tools Required
J 45059 Angle Meter. See Special Tools.
Fig. 660: Installing Flywheel - Manual Transmission
Courtesy of GENERAL MOTORS CORP.
1. Install the flywheel.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
2. Install new flywheel bolts.
Tighten:
1. Tighten the new flywheel bolts to 40 N.m (30 lb ft).
2. Use J 45059 to tighten the flywheel bolts an additional 45 degrees. See Special Tools.
ENGINE PRELUBING
Tools Required
J 45299 Engine Preluber. See Special Tools.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2006 Hummer H3
2006 ENGINE Engine Mechanical - 3.5L (L52) - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст