Hummer H3. Manual — part 64
Fig. 81: Generator Bracket Replacement
Courtesy of GENERAL MOTORS CORP.
1. Remove the generator. Refer to Generator Replacement (LH8) or Generator
Replacement (LLR).
2. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement .
3. Remove the engine wiring harness bracket bolt (4).
4. Reposition the engine wiring harness bracket out of the way.
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Fig. 82: View Of Generator Bracket & Bolts
Courtesy of GENERAL MOTORS CORP.
5. Remove the generator bracket bolts.
6. Remove the generator bracket from the vehicle.
7. Transfer any parts as needed.
Installation Procedure
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Fig. 83: View Of Generator Bracket & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Position the generator bracket in the vehicle.
2. Install the generator bracket bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
NOTE:
Refer to Fastener Notice .
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Fig. 84: Generator Bracket Replacement
Courtesy of GENERAL MOTORS CORP.
3. Position the engine wiring harness bracket to the generator bracket.
4. Install the engine wiring harness bracket bolt (4).
Tighten: Tighten the bolt to 40 N.m (29.5 lb ft).
5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement .
6. Install the generator. Refer to Generator Replacement (LH8) or Generator
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст