Hummer H3. Manual — part 63
1. Remove the intake manifold. Refer to Intake Manifold Replacement .
2. Remove the starter solenoid S terminal nut and disconnect the lead from the starter.
3. Remove the starter terminal nut (1) and disconnect the positive battery cable (2) from the
starter.
Fig. 78: Starter Motor
Courtesy of GENERAL MOTORS CORP.
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
4. Remove the starter motor nut (1) and bolt (4).
5. Remove the starter motor (3).
Installation Procedure
Fig. 79: Starter Motor
Courtesy of GENERAL MOTORS CORP.
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
1. Position the starter motor (3) over the stud (2).
2. Install the starter motor nut (1) and bolt (4).
Tighten: Tighten the bolt/nut to 50 N.m (37 lb ft).
Fig. 80: Starter Wiring
NOTE:
Refer to Fastener Notice .
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Courtesy of GENERAL MOTORS CORP.
3. Connect the battery positive cable (2) to the starter and install the starter terminal nut (1).
Tighten: Tighten the nut to 9 N.m (80 lb in).
4. Connect the lead to the starter solenoid and install the starter solenoid S terminal nut.
Tighten: Tighten the nut to 3.5 N.m (31 lb in).
5. Install the intake manifold. Refer to Intake Manifold Replacement .
GENERATOR BRACKET REPLACEMENT
Removal Procedure
2008 Hummer H3
2008 ENGINE Engine Electrical - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст