Hummer H3. Manual — part 1711
WINDSHIELD REPLACEMENT
Tools Required
J 24402-A Cold Knife Glass Sealant Remover. See Special Tools.
J 39032 Stationary Glass Removal Tool. See Special Tools.
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
Isopropyl Alcohol or Equivalent
Cartridge-type Caulking Gun
Commercial-type Utility Knife
Razor Blade Scraper
Suction Cups
Plastic Paddle
Removal Procedure
1. Open the hood.
2. Remove the window wiper arms. Refer to Windshield Wiper Arm Replacement .
3. Remove the window side reveal moldings from the vehicle. Refer to Windshield Side
Reveal Molding Replacement .
4. Remove the cowl air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel
Replacement .
5. Cover to protect the following parts from broken glass:
The upper dash pad
The defroster outlets and A/C outlets
The seats and carpeting
6. Remove the rearview mirror. Refer to Inside Rearview Mirror Replacement .
IMPORTANT: Before cutting out a stationary window, apply a double layer
of masking tape around the perimeter of the painted surfaces
and the interior trim.
CAUTION: If broken glass falls into the defroster outlets, it can be
blown into the passenger compartment and cause
personal injury.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3
Fig. 25: Identifying Window Lower Supports
Courtesy of GENERAL MOTORS CORP.
7. If necessary, remove the window lower supports (1) by using a flat-bladed tool, lightly
prying upward in the middle until it releases.
IMPORTANT: The window lower supports (1) have molded in locks with an
urethane adhesive strip (2) on the back side. Once the
window lower stops have been removed they must be
replaced.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3
Fig. 26: Separating Urethane Adhesive From Window
Courtesy of GENERAL MOTORS CORP.
8. This will allow the urethane adhesive to be separated from the window.
Leave a base of urethane on the pinchweld flange.
The only suitable lubrication is clear water.
Use J 24402-A , J 39032 or equivalent in order to remove the window. See Special
Tools.
IMPORTANT: Keep the cutting edge of the tool against the window.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3
Fig. 27: Separating Bottom Of Window From Urethane Adhesive
Courtesy of GENERAL MOTORS CORP.
9. Remove the bottom of the window from the urethane adhesive using a long utility knife or
similar tool. Keep the cutting edge of the utility knife against the glass.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст