Hummer H3. Manual — part 1233
2007 SUSPENSION
Front Suspension - H3
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
STABILIZER SHAFT REPLACEMENT
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Application
Specification
Metric
English
Hub and Bearing Assembly to Steering Knuckle
Bolts
180 N.m
133 lb ft
Lower Control Arm Ball Joint Stud Nut
First Pass
85 N.m
63 lb ft
Second Pass
Plus 60 Degrees
Lower Control Arm to Frame Bolts Front
165 N.m
122 lb ft
Lower Control Arm to Frame Bolts Rear
180 N.m
133 lb ft
Shock Absorber Tenon Nut
30 N.m
22 lb ft
Shock Absorber to Lower Control Arm Nut
80 N.m
59 lb ft
Stabilizer Shaft Insulator Clamp Bolts
50 N.m
37 lb ft
Stabilizer Shaft Link Nuts
80 N.m
59 lb ft
Upper Control Arm Ball Pinch Bolt Nut
70 N.m
51 lb ft
Upper Control Arm to Frame Nuts
155 N.m
114 lb ft
Wheel Speed Sensor Mounting Bracket Bolt
20 N.m
15 lb ft
2007 Hummer H3
2007 SUSPENSION Front Suspension - H3
2007 Hummer H3
2007 SUSPENSION Front Suspension - H3
Fig. 1: View Of Link Assembly
Courtesy of GENERAL MOTORS CORP.
2. Remove the nuts from the link assemblies.
3. Remove the link assemblies.
2007 Hummer H3
2007 SUSPENSION Front Suspension - H3
Fig. 2:
Courtesy of GENERAL MOTORS CORP.
4. Remove the insulator clamp bolts.
5. Remove the clamps.
6. Remove the stabilizer shaft.
7. Remove the insulators.
8. Inspect all of the parts for wear and damage.
Installation Procedure
1. Install the insulators to the stabilizer shaft.
2007 Hummer H3
2007 SUSPENSION Front Suspension - H3
Fig. 3:
Courtesy of GENERAL MOTORS CORP.
2. Install the stabilizer shaft.
3. Install the clamps over the insulators and the stabilizer shaft.
4. Install insulator clamp bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 SUSPENSION Front Suspension - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст