Hummer H3. Manual — part 1725

11. Ensure that the locator pins (1) are positioned into the locator slots on the upper pinch-weld

flange.

12. Use masking tape to mark the locations of the window in the opening.

13. Cut the masking in the center and remove the window from the opening.

Fig. 70: Applying Glass Prep
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use care when applying glass prep clear #1 on the window.

This primer dries almost instantly and may stain the viewing
area of the window if not applied evenly.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

14. Use a new dauber in order to apply glass prep clear #1 to the area approximately 18 mm

(0.71 in) around the entire perimeter of the window inner surface.

Immediately wipe the glass primed area using a clean, lint-free cloth.

Fig. 71: Applying Glass Prep
Courtesy of GENERAL MOTORS CORP.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

15. Apply a second coat of the glass prep clear #1 to the same area of the glass.

Fig. 72: Applying Glass Primer
Courtesy of GENERAL MOTORS CORP.

16. Shake the glass primer black #2 for at least 1 minute.

17. Use a new dauber in order to apply the glass primer black #2 to the same areas (2) that glass

prep clear #1 was applied.

18. Allow the glass primer to dry for approximately 10 minutes.

IMPORTANT: The glass primer black #2 is effective up to 8 hours after

applying it to the glass. The primed surface of the glass must
be kept clean.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3

Fig. 73: View Of Modified Applicator Nozzle
Courtesy of GENERAL MOTORS CORP.

19. Cut the applicator nozzle in order to provide a minimum urethane bead of 8 mm (0.31 in)

wide and 13 mm (0.5 in) high.

2007 Hummer H3

2007 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - H3