Hummer H3. Manual — part 1604
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .
Fig. 30: Removing Wheel Stud From Hub Flange
Courtesy of GENERAL MOTORS CORP.
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
4. Remove the wheel stud from the hub flange using the J 43631 .
5. Remove the wheel stud from the hub flange.
Installation Procedure
Fig. 31: View Of Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
Courtesy of GENERAL MOTORS CORP.
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the hub flange.
5. Remove the wheel nut.
6. Remove the washers.
7. Install the brake rotor. Refer to Rear Brake Rotor Replacement .
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
9. Remove the safety stands.
10. Lower the vehicle.
DESCRIPTION AND OPERATION
GENERAL DESCRIPTION
These vehicles use a leaf spring and a solid rear axle suspension system.
The rear axle assembly is attached to multi-leaf springs with U-bolts. The front ends of the springs
are attached to the frame at the front hangers with bolts and are isolated utilizing rubber bushings.
The rear ends of the springs are attached to the frame with bolts at the shackles. The shackles also
utilize rubber bushings for isolation. Shackles allow the springs to change position while the
vehicle is in motion.
Two direct double-acting shock absorbers provide ride control. The shock absorbers are angle-
mounted between the frame. The shock absorbers are attached to the anchor plate.
The rear spring steel stabilizing shaft helps minimize body roll and sway during cornering. The
rear stabilizer shaft is connected to the rear axle and the frame with the following components:
The rubber insulators
The clamps
The link assemblies
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS
Special Tools
Illustration
Tool Number/Description
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
J 21474-01
Control Arm Bushing Set
J 43631
Ball Joint Remover
2007 Hummer H3
2007 SUSPENSION Rear Suspension - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст