Hummer H3. Manual — part 459
Tool Required
J 41240 Fan Clutch Remover and Installer
Installation Procedure
Fig. 653: View Of Water Pump, Gasket & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install the NEW water pump gasket.
2. Install the water pump.
3. Install the water pump bolts.
Tighten: Tighten the water pump bolts to 10 N.m (89 lb in).
NOTE:
Refer to FASTENER NOTICE .
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 654: View Of Water Pump Pulley, Bolts & J 41240
Courtesy of GENERAL MOTORS CORP.
4. Install the water pump pulley.
5. Install the water pump pulley bolts.
6. Install J 41240 to hold pulley.
7. Tighten the water pump pulley bolts.
Tighten: Tighten the water pump pulley bolts to 25 N.m (18 lb ft).
8. Remove J 41240 .
CRANKSHAFT REAR OIL SEAL AND HOUSING INSTALLATION
Tools Required
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
J 44219 Cover Alignment Pins. See Special Tools.
Installation Procedure
Fig. 655: Locating Rear Block Sealing Surface Adhesive
Courtesy of GENERAL MOTORS CORP.
1. Apply a 3 mm (0.12 in) bead of GM P/N 12378521 (Canadian P/N 88901148) to the rear
sealing surface of the block (1).
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Fig. 656: View Of Crankshaft Rear Oil Seal Housing
Courtesy of GENERAL MOTORS CORP.
2. Install J 44219 into the block. See Special Tools.
3. Slide the crankshaft rear oil seal housing and bolts over the J 44219 and crankshaft, except
IMPORTANT: The crankshaft rear oil seal housing must be installed within
10 minutes from the time the sealer was applied.
IMPORTANT: With the help of the plastic installation aid (supplied with the
new seal), be sure the lip of the seal faces inward.
2007 Hummer H3
2007 ENGINE Engine Mechanical - 3.7L - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст