Hummer H3. Manual — part 1429
Fig. 89: View Of Stop Lamp Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
2. Rotate the switch counterclockwise.
3. Remove the switch from the bracket.
4. Remove the switch from the vehicle.
Installation Procedure
1. Position the switch near the bracket.
2. Ensure the switch key-way is properly indexed to the plastic retainer.
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
3. Install and adjust the switch. Refer to Stop Lamp Switch Adjustment.
Fig. 90: View Of Stop Lamp Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
4. Connect the stop lamp switch electrical connectors (1).
5. Check the switch for proper operation.
HEADLAMP SWITCH REPLACEMENT
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Fig. 91: Headlamp Switch Replacement
Courtesy of GENERAL MOTORS CORP.
Headlamp Switch Replacement
Callout
Component Name
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
FRONT SIDE DOOR JAMB SWITCH REPLACEMENT
Fig. 92: Door Jamb Switch Replacement - Front
Courtesy of GENERAL MOTORS CORP.
Front Side Door Jamb Switch Replacement
Fastener Tightening Specifications: Refer to Fastener Tightening
Specifications.Preliminary Procedure: Remove the left knee bolster panel. Refer to
Driver Knee Bolster Replacement (Left Hand Drive) or Driver Knee Bolster
Replacement (Right Hand Drive) .
1
Screw, Headlamp Switch
Tighten: 2 N.m (18 lb in)
2
Switch Assembly, Headlamp
Tip: Disconnect the electrical connector.
Callout
Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.
NOTE:
Refer to Fastener Notice .
1
Screw, Door Jamb Switch (Qty: 1)
Tighten: 2 N.m (18 lb in)
2007 Hummer H3
2007 ACCESSORIES & EQUIPMENT Lighting - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст