Hummer H3. Manual — part 597
Fig. 51: View Of PSIR Bracket To I/P Structure Fasteners
Courtesy of GENERAL MOTORS CORP.
2. Install the 2 fasteners retaining the PSIR bracket to the I/P structure.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
3. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement (Left Hand
Drive) or Instrument Panel Assembly Replacement (Right Hand Drive) .
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 52: View Of PSIR Module
Courtesy of GENERAL MOTORS CORP.
4. Position the PSIR inflator module to the front of the I/P and connect the electrical
connector.
5. Connect the CPA.
6. Install the PSIR inflator module to the I/P.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 53: View Of PSIR Inflator Module Fasteners
Courtesy of GENERAL MOTORS CORP.
7. Partially Install the 2 lower fasteners retaining the PSIR module to the I/P structure.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 54: View Of PSIR Module Retaining Nuts
Courtesy of GENERAL MOTORS CORP.
8. Install the 2 side retaining nuts (1) to the PSIR inflator module.
Tighten: Tighten the 4 PSIR fasteners until fully driven, seated and not stripped.
9. Install the digital radio receiver, if equipped. Refer to Digital Radio Receiver
Replacement .
10. Install the radio. Refer to Radio Replacement .
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст