Hummer H3. Manual — part 596
Fig. 47: View Of PSIR Module
Courtesy of GENERAL MOTORS CORP.
11. Partially remove the PSIR inflator module from the I/P.
12. Disconnect the connector position assurance (CPA).
13. Disconnect the electrical connector from the PSIR module.
14. Remove the PSIR inflator module from the vehicle.
15. Fully deploy the module before disposal. If the module is being replaced under warranty,
fully deploy and dispose of the module after the required retention period. Refer to Inflator
Module Handling and Scrapping.
16. If replacing the PSIR bracket, remove the I/P assembly. Refer to Instrument Panel
Assembly Replacement (Left Hand Drive) or Instrument Panel Assembly
Replacement (Right Hand Drive) .
IMPORTANT: If the PSIR module has deployed while attached to the I/P, the
PSIR bracket MUST be replaced.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 48: View Of PSIR Bracket To I/P Structure Fasteners
Courtesy of GENERAL MOTORS CORP.
17. Remove the 2 fasteners retaining the PSIR bracket to the I/P structure.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 49: View Of PSIR Bracket
Courtesy of GENERAL MOTORS CORP.
18. Remove the PSIR bracket from the vehicle.
Installation Procedure
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Fig. 50: View Of PSIR Bracket
Courtesy of GENERAL MOTORS CORP.
1. If replacing the PSIR bracket, install the PSIR bracket to the I/P structure.
2007 Hummer H3
2007 RESTRAINTS Supplemental Inflatable Restraints - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст