Hummer H3. Manual — part 1009
6. Install the U-bolt nuts.
Tighten: Tighten the nuts to 76 N.m (56 lb ft).
7. Install the bottom shock absorber nut and bolt.
Tighten: Tighten the nuts to 95 N.m (70 lb ft).
Fig. 101: Locating Brake Line Retaining Clips
Courtesy of GENERAL MOTORS CORP.
NOTE:
Refer to Fastener Notice .
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
8. Install the brake pipes.
Tighten: Tighten the brake lines to 19 N.m (14 lb ft).
9. Install the retaining clips for the brake line.
Fig. 102: View Of Rear Leaf Spring Park Brake Cable Retaining Bolt
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Always use a backup wrench when tightening the brake
pipes.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
10. Install the retaining bolts for the park brake cables at the rear leaf springs.
Tighten: Tighten the nuts to 20 N.m (15 lb ft).
Fig. 103: Locating Rear Speed Sensor Retaining Clips
Courtesy of GENERAL MOTORS CORP.
11. Install the rear speed sensors retainers in the frame. Refer to Rear Wheel Speed Sensor
Replacement .
12. Reconnect the speed sensor electrical connector.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Fig. 104: Identifying Axle Housing Vent Hose
Courtesy of GENERAL MOTORS CORP.
13. Install the vent hose on the axle housing.
2007 Hummer H3
2007 Driveline/Axle Rear Drive Axle - H3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст