Hummer H2. Manual — part 2135
Fig. 81: Installing Pitman Shaft Boot, Pitman Arm & Lock Washer To Steering Gear
Courtesy of GENERAL MOTORS CORP.
8. Install the pitman shaft boot (2).
9. Install the pitman arm (3) to the steering gear (1).
10. Install the lock washer (4).
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
11. Install the nut (5).
Tighten: Tighten the pitman arm nut to 250 N.m (184 lb ft).
12. Refer to Pitman Shaft Over-Center Preload Adjustment - Off Vehicle (670 Gear) to adjust the pitman
shaft.
STEERING GEAR CHECK VALVE REPLACEMENT - OFF VEHICLE
Disassembly Procedure
Fig. 82: Removing Check Valve From Steering Gear Housing
Courtesy of GENERAL MOTORS CORP.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Do not to damage the threads of the steering gear housing when removing the
check valve.
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Remove the check valve (1) from the steering gear housing (2) using a small screwdriver.
Assembly Procedure
Fig. 83: Installing Check Valve
Courtesy of GENERAL MOTORS CORP.
Install the check valve (1) using a 9.52mm inch diameter piece of tubing 100 mm (4 in) long to drive into the
steering gear housing.
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
STEERING GEAR THRUST SUPPORT REPLACEMENT - OFF VEHICLE (700 GEAR)
Tools Required
z
J 42882 Adjuster Nut Socket. See Special Tools and Equipment .
z
J 43435 Adjuster Lock Nut Wrench
Disassembly Procedure
2004 Hummer H2
2004 STEERING Power Steering System - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст